Model-specific code library

Thermador dishwasher Water and power supply codes

12 printed codes in this group: E14, E15, E16, E17, E18, E27, E3000, E3100, E3200, E3300 and 2 more.

Gloved hand holding a dishwasher inlet valve joined by hose to a clear flow meter, with the dishwasher's power plug lying unplugged on the floor
Experienced techniciansWarranty on our workmanshipOEM parts available on orderUpfront pricing, agreed before work

Water and power supply codes

E14

E14 means the flow meter has failed or water is not entering the dishwasher through the filling system. The Thermador manual gives no owner step; note the display and book a visit.

Check, then book
E15

E15 means the safety switch found water in the base of the Thermador dishwasher and the leakage protection activated. Shut the water valve that feeds the dishwasher, then book a technician.

Shut off water, book
E16

E16 suggests water may not be getting into the Thermador dishwasher through the filling system. Inspect the inlet hose for kinks and damage.

Check, then book
E17

E17 shares one entry with E16: water may not be able to enter the dishwasher through the filling system. Look along the inlet hose for a kink or any damage.

Check, then book
E18

E18 means the water level is too low or water is not being pumped properly. Start with the inlet hose and look for kinks, then confirm the water supply is on; the Thermador manual gives 10 l/min as the flow rate.

Check, then book
E27

E27 means the supply voltage is too low. Thermador adds that this is not a failure of the dishwasher itself; have your home's voltage and electrical system checked by a professional electrician.

Check supply
E3000

E3000 reports a flow meter failure or an issue with water flowing into the dishwasher or the filling system. No owner step is printed; note the display and book a visit.

Shut off water, book
E3100

E3100 means the safety switch detected water in the base of the dishwasher and the leakage protection is active. Turn off the water inflow, then book a technician.

Shut off water, book
E3200

E3200 reports an issue with water flowing into the dishwasher: the level is too low or water is not pumped correctly. Check the inlet hose, confirm the supply is on (10 l/min), then see the DWHD660EFM guide.

Check, then book
E3300

E3300 shares an entry with E3400 on Thermador's page: there is an issue with water flowing into the dishwasher or the filling system, and water may not be able to enter. Check that the inlet hose is not kinked or damaged.

Check, then book
E3400

E3400 is read two ways. Thermador's support page groups it with E3300 as a filling problem where water may not enter; the DWHD660EFM guide shows E:34-00 as water running in continuously, and says to close the water supply valve.

Check, then book
E9001

E9001 means the house power supply to the dishwasher is too low. Reset the breaker for 30 seconds; if E9001 comes back, have an electrician check the incoming voltage. The guide says E:90-01 is no problem with the appliance.

Check supply

Let’s take care of it.

One burner, two burners,
or the whole range.