What it means
E16 suggests water may not be getting into the Thermador dishwasher through the filling system. Inspect the inlet hose for kinks and damage.
Thermador dishwasher E16 / Water and power supply
E16 suggests water may not be getting into the Thermador dishwasher through the filling system. Inspect the inlet hose for kinks and damage.
Also appears as E16
E16 suggests water may not be getting into the Thermador dishwasher through the filling system. Inspect the inlet hose for kinks and damage.
Follow the inlet hose from the tap to the dishwasher.
The hose is straight and undamaged but the display holds the code.
Your Thermador steps, stored on this device only

Follow the inlet hose from the tap to the dishwasher.

A kinked hose restricts flow.

Cracks or crushing mean replacement.

If the hose is fine and E16 stays.
Give us your model number and the checks you already made, then start your request below.
Book a visit
A simplified drawing, since the layout shifts from one model to the next. Tap any outlined part for its photo and the check that goes with it.
It is the one owner check listed for filling problems.
Read the supporting manualThe manual prints them as one entry.
Read the supporting manualE18 mentions low water or pumping; E16 only the inlet.
Read the supporting manualThe guide's E:32-00 row lists an inlet hose that is kinked or blocked, for which it says to contact service, and a water supply valve that is jammed or clogged, where the flow rate must be at least 10 l/min with the valve open.
Read the supporting manualManufacturer document
Thermador / BSH Home Appliances (thermador.com/us support page)
Undated web page; fetched 12.11.2026 / entry "E16 or E17"
Manufacturer document
BSH Home Appliances Corporation (Thermador US manual PDF, media3.bsh-group.com)
PDF created 05.08.2026; file tag _C (no printed edition date read) / PDF p33-34
Source: the dishwasher error-code page from Thermador, entry E16 or E17. The DWHD660EFM guide is cited for its inlet-hose and flow-rate row (E:32-00).
Probably not to look. Follow the inlet hose from the tap to the dishwasher by eye and straighten any kink, without straining the hose.
Worth checking, though the E16 page asks only about the inlet hose. A closed supply valve is a plain way for water not to enter, and the DWHD660EFM guide lists it under its E:32-00 row.
Yes, in the newer style. E3300 and E3400 carry the same wording as E16 and E17 on another display style: water may not be able to enter, so check the inlet hose.
Book a visit if you find damage on the hose, or if the hose is straight and undamaged but the display still holds the code.
The E16 entry gives none. The E18 entry and the DWHD660EFM guide give 10 l/min as the minimum flow with the supply valve open, so mention a weak water supply when you book.
Thermador messages, symptoms, parts, repair visits
E3300 shares an entry with E3400 on Thermador's page: there is an issue with water flowing into the dishwasher or the filling system, and water may not be able to enter. Check that the inlet hose is not kinked or damaged.
For a Thermador dishwasher that leaves water behind, the error-code page lists the same four steps for E22, E24 and E25: filter, drain pump cover, drain hose and air gap or hose. The DWHD660EFM guide adds two checks for a display reading E:61-03: remove the garbage disposal plug and keep a high loop in the hose.
Book a diagnostic made for your exact model and performed at the appliance itself.
Where the offices are, and what to tell us about getting in.