Inside the appliance
Dishwasher leakage safety switch (water protection system). In plain English.
The dishwasher leakage safety switch sits in the base of a Thermador dishwasher and detects water there. When it does, the leakage protection (water protection system) activates and the display shows E15, E3100 or E:31-00. Thermador's step is to turn off the water supply; the cause needs a technician.

Where it fits.
Dishwasher leakage safety switch (water protection system) in the appliance
The base of the dishwasher, as the support page words it.
The picture stands for a type of component. Which replacement suits your model is a separate question.
What shifts when this system needs a look.
Dishwasher leakage safety switch (water protection system) concerns may show up next to a drop in performance or a message that keeps returning. Testing comes before any verdict on the component.
Owner care, within the model instructions.
Turn the appliance off and pull the plug before doing any check yourself. Look out for standing water and sharp edges. Never handle a wet plug, remove a service panel or step beyond what your model's guide permits an owner.
- 1
Close the water supply
Turn off the water inflow first. The guide says to close the water supply valve.
- 2
Look at the floor
Check for water under or around the dishwasher.
- 3
Keep the dishwasher idle
Do not start cycles while the leakage protection is active.
- 4
Dry what you can see
Wipe up standing water on the floor and in the cabinet, with the dishwasher's power off at the breaker.
- 5
Note the display
Write down the exact code and the model number for the visit.
Cleaning or replacement?
Leave internal testing to a technician.
E15, E3100 or E:31-00 is on the display.
Water is visible under or around the dishwasher.
The message returns after the water is dried and the supply is on.
Arrange a diagnosticSources and model boundaries.
These documents back up the Dishwasher leakage safety switch (water protection system) guidance. Choose the manual written for your model.
- Error Codes | Dishwashers Support | Thermador
- Use and care guide, Dishwasher DWHD660EFM (en-us)
Match your model to the guide it shipped with. See how we research these pages.
What does E15 mean on a Thermador dishwasher?
The safety switch has detected water in the base and the leakage protection has activated. Turn off the water inflow.
What is the water protection system?
The guide uses this name for E:30-00 and E:31-00: the system is activated and you should close the water supply valve.
Can I keep using the dishwasher?
No. Leave it idle, close the water supply and book a technician, who finds where the water entered the base.
Is E3100 the same as E15?
Both entries describe the safety switch finding water in the base. E3100 is the four-digit form.
Where does the water come from?
Neither Thermador source says. A technician traces the source of the leak.
Thermador messages, symptoms, parts, repair visits
Move from the message to your next step.
E15
E15 means the safety switch found water in the base of the Thermador dishwasher and the leakage protection activated. Shut the water valve that feeds the dishwasher, then book a technician.
Thermador dishwasher not draining
For a Thermador dishwasher that leaves water behind, the error-code page lists the same four steps for E22, E24 and E25: filter, drain pump cover, drain hose and air gap or hose. The DWHD660EFM guide adds two checks for a display reading E:61-03: remove the garbage disposal plug and keep a high loop in the hose.
Dishwasher repair
Book a diagnostic made for your exact model and performed at the appliance itself.
Find your metro
Where the offices are, and what to tell us about getting in.


