Inside the appliance
Dishwasher drain pump. In plain English.
The drain pump sends used wash water out of a Thermador dishwasher. Thermador's pages tie it to E22, E23, E24, E25, E6101, E6102 and E6103. Owner steps: reseat the cover over the pump, straighten the drain hose and clear the air gap. A code that keeps returning means a visit.

Where it fits.
Dishwasher drain pump in the appliance
It lies under a pry-off cover set into the tub floor. The DWHD660EFM guide has you lift out the filter system, scoop out water and pry the cover up, which exposes the impeller.
The picture stands for a type of component. Which replacement suits your model is a separate question.
What shifts when this system needs a look.
Dishwasher drain pump concerns may show up next to a drop in performance or a message that keeps returning. Testing comes before any verdict on the component.
Owner care, within the model instructions.
Turn the appliance off and pull the plug before doing any check yourself. Look out for standing water and sharp edges. Never handle a wet plug, remove a service panel or step beyond what your model's guide permits an owner.
- 1
Open the pump cover
For E22 and E24, Thermador says to lift off the drain pump cover, remove standing water and loose debris, then press the cover back until it clicks shut.
- 2
Straighten the drain hose
The same entries ask you to look at the drain pump hose and make sure it is not kinked or sharply bent.
- 3
Check the air gap and hose
Switch the dishwasher off, check the air gap, lower the drain hose into a bucket, clear debris, reconnect it and run a rinse to test.
Cleaning or replacement?
Leave internal testing to a technician.
The code is E23 or E6101: the page offers no owner step for either.
You have reseated the cover, straightened the hose and cleared the air gap, yet E22, E24, E25, E6102 or E6103 stays.
Arrange a diagnosticSources and model boundaries.
These documents back up the Dishwasher drain pump guidance. Choose the manual written for your model.
- Error Codes | Dishwashers Support | Thermador
- Error Codes | Dishwashers Support | Thermador
- Use and care guide, Dishwasher DWHD660EFM (en-us)
Match your model to the guide it shipped with. See how we research these pages.
Which Thermador codes name the drain pump?
E23 and E6101 call the pump blocked, clogged or failing. E22, E24, E25, E6102 and E6103 list a loose pump cover as one of several causes.
Is there a Thermador step for E23?
The E23 entry prints no owner step. The cover, hose and air gap steps sit under E22, E24 and E25.
Can broken glass block the pump?
The DWHD660EFM guide warns that sharp debris such as glass fragments can sit in the pump, so take care when you lift parts out.
When should I book a technician?
Book once E23 or E6101 appears, or once any other drain code survives those three steps.
Thermador messages, symptoms, parts, repair visits
Move from the message to your next step.
E22
E22 has several possible causes on Thermador's page: a blocked filter, a blocked drain pump or loose pump cover, a kinked pump hose, or a clogged air gap or drain hose. Start with the filter, then work down the list.
Thermador dishwasher not draining
For a Thermador dishwasher that leaves water behind, the error-code page lists the same four steps for E22, E24 and E25: filter, drain pump cover, drain hose and air gap or hose. The DWHD660EFM guide adds two checks for a display reading E:61-03: remove the garbage disposal plug and keep a high loop in the hose.
Dishwasher repair
Book a diagnostic made for your exact model and performed at the appliance itself.
Find your metro
Where the offices are, and what to tell us about getting in.

