What it means
E23 on Thermador's page says the drain pump is blocked, clogged or faulty, with no owner step printed. Look for standing water, note whether the tub drains at all, and book a visit.
Thermador dishwasher E23 / Drain pump
E23 on Thermador's page says the drain pump is blocked, clogged or faulty, with no owner step printed. Look for standing water, note whether the tub drains at all, and book a visit.
Also appears as E23
E23 on Thermador's page says the drain pump is blocked, clogged or faulty, with no owner step printed. Look for standing water, note whether the tub drains at all, and book a visit.
Standing water after a cycle confirms a drain problem, so check the bottom of the tub once it has stopped.
Water is left in the tub.
Your Thermador steps, stored on this device only

Standing water after a cycle confirms a drain problem, so check the bottom of the tub once it has stopped.

Write down whether it fails every cycle or only after certain loads, since a technician will ask.

If your display shows E24 instead, Thermador gives a pump-cover and hose checklist that this code does not have.

The Thermador manual lists no owner steps for this code, so a technician has to test the pump.
Give us your model number and the checks you already made, then start your request below.
Book a visit
A simplified drawing, since the layout shifts from one model to the next. Tap any outlined part for its photo and the check that goes with it.

Component reference
The drain pump sends used wash water out of a Thermador dishwasher.
Read the definitionThe pump is blocked, clogged or faulty. The Thermador manual names no further cause and no owner step.
Read the supporting manualE22 and E24 come with checklists for the filter, pump cover, hoses and air gap. E23 comes with none, which is why we keep it as its own page.
Read the supporting manualBoth name the drain pump in the same words, one in the shorter style and one in the four-digit style.
Read the supporting manualManufacturer document
Thermador / BSH Home Appliances (thermador.com/us support page)
Undated web page; fetched 12.11.2026 / entry "E23"
Source: the Thermador dishwasher error-code page, entry E23.
The Thermador manual for E23 lists no steps. The related E24 entry does, but it is a separate message.
Possibly. A blocked pump keeps water from leaving, so check the tub after a cycle.
The Thermador manual does not rate it, but standing water should be removed before the next use.
The code, the model, and whether water was left in the tub.
Thermador messages, symptoms, parts, repair visits
E6101 says the drain pump is blocked, clogged or faulty, with no owner step printed. Look for standing water in the tub and book a visit.
For a Thermador dishwasher that leaves water behind, the error-code page lists the same four steps for E22, E24 and E25: filter, drain pump cover, drain hose and air gap or hose. The DWHD660EFM guide adds two checks for a display reading E:61-03: remove the garbage disposal plug and keep a high loop in the hose.
The drain pump sends used wash water out of a Thermador dishwasher. Thermador's pages tie it to E22, E23, E24, E25, E6101, E6102 and E6103. Owner steps: reseat the cover over the pump, straighten the drain hose and clear the air gap. A code that keeps returning means a visit.
Book a diagnostic made for your exact model and performed at the appliance itself.
Where the offices are, and what to tell us about getting in.