What it means
E25 shares its checklist with E24: a blocked drain pump or loose cover, a kinked pump hose, and a clogged air gap or drain hose. Work through them in that order and finish with a rinse cycle.
Thermador dishwasher E25 / Drain pump
E25 shares its checklist with E24: a blocked drain pump or loose cover, a kinked pump hose, and a clogged air gap or drain hose. Work through them in that order and finish with a rinse cycle.
Also appears as E25
E25 shares its checklist with E24: a blocked drain pump or loose cover, a kinked pump hose, and a clogged air gap or drain hose. Work through them in that order and finish with a rinse cycle.
Remove the cover, clear standing water and debris, and click the cover back on.
E25 returns once the cover and hose are checked.
Your Thermador steps, stored on this device only

Remove the cover, clear standing water and debris, and click the cover back on.

Look for a bend or kink along its length.

Check it for debris after switching the appliance off.

Disconnect it into a bucket, clear it, reconnect and run a rinse cycle.
Give us your model number and the checks you already made, then start your request below.
Book a visit
A simplified drawing, since the layout shifts from one model to the next. Tap any outlined part for its photo and the check that goes with it.

Component reference
The drain pump sends used wash water out of a Thermador dishwasher.
Read the definitionOn the Thermador manual, no. Thermador prints identical steps for E24 and E25, so the meaning and the remedy match.
Read the supporting manualIt says several issues can trigger the code, from a loose pump cover to a clogged drain hose.
Read the supporting manualA rinse cycle after the checks, to see whether the message stays away.
Read the supporting manualManufacturer document
Thermador / BSH Home Appliances (thermador.com/us support page)
Undated web page; fetched 12.11.2026 / entry "E25 / E-25"
Source: the Thermador dishwasher error-code page, entry E25 / E-25.
Yes, the Thermador manual prints E25 and E-25 together.
The Thermador manual says the air gap or drain hose may be clogged with debris.
A bucket to stand the disconnected drain hose in.
If the issue still exists after the checks.
Thermador messages, symptoms, parts, repair visits
E24 has three listed causes on Thermador's page: a blocked drain pump or loose cover, a kinked pump hose, and a clogged air gap or drain hose. Open the pump cover first, then check the hose and air gap.
For a Thermador dishwasher that leaves water behind, the error-code page lists the same four steps for E22, E24 and E25: filter, drain pump cover, drain hose and air gap or hose. The DWHD660EFM guide adds two checks for a display reading E:61-03: remove the garbage disposal plug and keep a high loop in the hose.
The drain pump sends used wash water out of a Thermador dishwasher. Thermador's pages tie it to E22, E23, E24, E25, E6101, E6102 and E6103. Owner steps: reseat the cover over the pump, straighten the drain hose and clear the air gap. A code that keeps returning means a visit.
Book a diagnostic made for your exact model and performed at the appliance itself.
Where the offices are, and what to tell us about getting in.