What it means
E15 means the safety switch found water in the base of the Thermador dishwasher and the leakage protection activated. Shut the water valve that feeds the dishwasher, then book a technician.
Thermador dishwasher E15 / Water and power supply
E15 means the safety switch found water in the base of the Thermador dishwasher and the leakage protection activated. Shut the water valve that feeds the dishwasher, then book a technician.
Also appears as E15
E15 means the safety switch found water in the base of the Thermador dishwasher and the leakage protection activated. Shut the water valve that feeds the dishwasher, then book a technician.
Wet electrics are dangerous.
E15 shows on the display.
Your Thermador steps, stored on this device only

Turn off the water inflow first.

Look for water under or around the dishwasher.

Leave the dishwasher idle.

A technician finds the leak source.
Give us your model number and the checks you already made, then start your request below.
Book a visitA simplified drawing, since the layout shifts from one model to the next. Tap any outlined part for its photo and the check that goes with it.

Component reference
The dishwasher leakage safety switch sits in the base of a Thermador dishwasher and detects water there.
Read the definitionThe safety switch found water sitting in the machine's base.
Read the supporting manualThe Thermador manual says to turn off the inflow.
Read the supporting manualE14 concerns water intake; E15 concerns a leak.
Read the supporting manualThat guide prints two messages with the cause "Water protection system is activated": E:30-00 and E:31-00. For both, step one is to close the water supply valve and step two is to contact service.
Read the supporting manualManufacturer document
Thermador / BSH Home Appliances (thermador.com/us support page)
Undated web page; fetched 12.11.2026 / entry "E15"
Manufacturer document
BSH Home Appliances Corporation (Thermador US manual PDF, media3.bsh-group.com)
PDF created 05.08.2026; file tag _C (no printed edition date read) / PDF p33-34
Source: the dishwasher error-code page from Thermador, entry E15. The DWHD660EFM guide prints the four-digit water protection messages.
The switch detected water in the base of the dishwasher and the leakage protection activated, so treat it as a real leak until a technician finds the source.
The Thermador manual lists no reset. Shut the water valve that feeds the dishwasher and book a technician instead of running another cycle.
If water is on the floor, keep clear of the outlet. The checks also say not to run the dishwasher, so leave it idle until a technician has found the leak source.
Yes. E15 and E3100 print the same leak wording on different display styles, so treat them as one problem. E14, by contrast, is a water-intake problem.
The support page says E15 and E3100 share one wording, and the guide's E:31-00 reads as the four-digit display form of E3100. The guide describes it as the water protection system being activated and tells you to close the water supply valve.
Thermador messages, symptoms, parts, repair visits
E3100 means the safety switch detected water in the base of the dishwasher and the leakage protection is active. Turn off the water inflow, then book a technician.
For a Thermador dishwasher that leaves water behind, the error-code page lists the same four steps for E22, E24 and E25: filter, drain pump cover, drain hose and air gap or hose. The DWHD660EFM guide adds two checks for a display reading E:61-03: remove the garbage disposal plug and keep a high loop in the hose.
The dishwasher leakage safety switch sits in the base of a Thermador dishwasher and detects water there. When it does, the leakage protection (water protection system) activates and the display shows E15, E3100 or E:31-00. Thermador's step is to turn off the water supply; the cause needs a technician.
Book a diagnostic made for your exact model and performed at the appliance itself.
Where the offices are, and what to tell us about getting in.