What it means
E3000 reports a flow meter failure or an issue with water flowing into the dishwasher or the filling system. No owner step is printed; note the display and book a visit.
Thermador dishwasher E3000 / Water and power supply
E3000 reports a flow meter failure or an issue with water flowing into the dishwasher or the filling system. No owner step is printed; note the display and book a visit.
Also appears as E3000
E3000 reports a flow meter failure or an issue with water flowing into the dishwasher or the filling system. No owner step is printed; note the display and book a visit.
Make sure the water tap feeding the dishwasher is fully open.
E3000 appears.
Your Thermador steps, stored on this device only

Make sure the water tap feeding the dishwasher is fully open.

A kink at the inlet restricts flow; the neighboring E16 entry suggests this check.

Write down whether any water enters the tub at all.

A technician can test the flow meter, which the Thermador manual names as a possible failure.
Give us your model number and the checks you already made, then start your request below.
Book a visit
A simplified drawing, since the layout shifts from one model to the next. Tap any outlined part for its photo and the check that goes with it.

Component reference
The flow meter measures water entering a Thermador dishwasher.
Read the definitionA flow meter failure, or an issue with water flowing into the dishwasher or its filling system.
Read the supporting manualYes. E14 prints the same wording in the shorter display style.
Read the supporting manualOnly the basic supply checks. The Thermador manual lists no steps for the flow meter itself.
Read the supporting manualManufacturer document
Thermador / BSH Home Appliances (thermador.com/us support page)
Undated web page; fetched 12.11.2026 / entry "E3000"
Manufacturer document
BSH Home Appliances Corporation (Thermador US manual PDF, media3.bsh-group.com)
PDF created 05.08.2026; file tag _C (no printed edition date read) / PDF p33-35 (troubleshooting table)
Source: the Thermador dishwasher error-code page, entry E3000.
No, E3000 is not a leak message. Thermador lists the leakage protection message as E3100.
No, Thermador prints no reset for E3000. Note the display and book a visit.
Yes, a closed tap would stop water entering, so check it first.
If water is reaching the tub and E3000 stays, yes.
Thermador messages, symptoms, parts, repair visits
E14 means the flow meter has failed or water is not entering the dishwasher through the filling system. The Thermador manual gives no owner step; note the display and book a visit.
For a Thermador dishwasher that leaves water behind, the error-code page lists the same four steps for E22, E24 and E25: filter, drain pump cover, drain hose and air gap or hose. The DWHD660EFM guide adds two checks for a display reading E:61-03: remove the garbage disposal plug and keep a high loop in the hose.
The flow meter measures water entering a Thermador dishwasher. Thermador's E14 and E3000 entries describe a flow meter failure or a problem with the fill path and print no owner step. E16, E17, E18, E3200, E3300 and E3400 add inlet hose and supply checks.
Book a diagnostic made for your exact model and performed at the appliance itself.
Where the offices are, and what to tell us about getting in.