What it means
E17 shares one entry with E16: water may not be able to enter the dishwasher through the filling system. Look along the inlet hose for a kink or any damage.
Thermador dishwasher E17 / Water and power supply
E17 shares one entry with E16: water may not be able to enter the dishwasher through the filling system. Look along the inlet hose for a kink or any damage.
Also appears as E17
E17 shares one entry with E16: water may not be able to enter the dishwasher through the filling system. Look along the inlet hose for a kink or any damage.
Do not strain the hose.
The hose is straight and undamaged but the display holds the code.
Your Thermador steps, stored on this device only

Do not strain the hose.

Look at bends behind the cabinet.

Confirm it is open.

If nothing is wrong with the hose.
Give us your model number and the checks you already made, then start your request below.
Book a visit
A simplified drawing, since the layout shifts from one model to the next. Tap any outlined part for its photo and the check that goes with it.
Thermador does not separate them.
Read the supporting manualThe Thermador manual does not list parts.
Read the supporting manualE3400 uses the same wording in the newer style.
Read the supporting manualNot fully. The support page groups E3300 and E3400 with E16 and E17: water may not be able to enter, so check the inlet hose. The DWHD660EFM guide prints E:34-00 with a different cause, water continuously running into the appliance, and tells you to close the water supply valve and contact service.
Read the supporting manualManufacturer document
Thermador / BSH Home Appliances (thermador.com/us support page)
Undated web page; fetched 12.11.2026 / entry "E16 or E17"
Manufacturer document
BSH Home Appliances Corporation (Thermador US manual PDF, media3.bsh-group.com)
PDF created 05.08.2026; file tag _C (no printed edition date read) / PDF p33-34
Source: the dishwasher error-code page from Thermador, entry E16 or E17. The DWHD660EFM guide prints E:34-00 with a different meaning than the support page's E3400.
Book a visit. If the hose is straight and undamaged and the tap is open, nothing more is printed for you to check, and the flow rate is something a technician can measure.
Not stated. The Thermador manual names only the filling system and the inlet hose for E17, and lists no pump or other part.
Not without water. E17 says water may not be able to enter the dishwasher, so a cycle cannot run properly until the hose and the tap are sorted out.
Not stated. The Thermador manual gives no warning about harm to the dishwasher; if you find damage on the hose, book a visit.
The DWHD660EFM guide covers a closed supply valve under E:32-00: open it, end the cycle, start a new one, and contact service if it returns. E17 itself has no printed valve step.
Thermador messages, symptoms, parts, repair visits
E3300 shares an entry with E3400 on Thermador's page: there is an issue with water flowing into the dishwasher or the filling system, and water may not be able to enter. Check that the inlet hose is not kinked or damaged.
For a Thermador dishwasher that leaves water behind, the error-code page lists the same four steps for E22, E24 and E25: filter, drain pump cover, drain hose and air gap or hose. The DWHD660EFM guide adds two checks for a display reading E:61-03: remove the garbage disposal plug and keep a high loop in the hose.
Book a diagnostic made for your exact model and performed at the appliance itself.
Where the offices are, and what to tell us about getting in.