What it means
E27 means the supply voltage is too low. Thermador adds that this is not a failure of the dishwasher itself; have your home's voltage and electrical system checked by a professional electrician.
Thermador dishwasher E27 / Water and power supply
E27 means the supply voltage is too low. Thermador adds that this is not a failure of the dishwasher itself; have your home's voltage and electrical system checked by a professional electrician.
Also appears as E27
E27 means the supply voltage is too low. Thermador adds that this is not a failure of the dishwasher itself; have your home's voltage and electrical system checked by a professional electrician.
Dim lights or tripping breakers elsewhere point at the house supply rather than the dishwasher.
E27 appears regularly.
Your Thermador steps, stored on this device only

Dim lights or tripping breakers elsewhere point at the house supply rather than the dishwasher.

The Thermador manual does not call for any work on the appliance.

Have the home's voltage and electrical system checked, as the Thermador manual advises.

If the supply tests fine and E27 stays, we will look at the dishwasher.
Give us your model number and the checks you already made, then start your request below.
Book a visit
A simplified drawing, since the layout shifts from one model to the next. Tap any outlined part for its photo and the check that goes with it.
The supply voltage is too low. Thermador says this is not an error of the appliance itself.
Read the supporting manualBoth report low supply voltage, E27 in the older two-digit style and E9001 in the four-digit style.
Read the supporting manualA professional electrician checks the home's voltage and electrical system.
Read the supporting manualManufacturer document
Thermador / BSH Home Appliances (thermador.com/us support page)
Undated web page; fetched 12.11.2026 / entry "E27"
Source: the Thermador dishwasher error-code page, entry E27.
The Thermador manual says it is not an appliance error.
The Thermador manual lists no reset for E27, only the electrician check.
The Thermador manual does not rate it, so avoid repeated attempts until the supply is checked.
Tell us what the electrician found, if anything. That detail helps decide the next step, since Thermador says E27 is not a failure of the dishwasher itself.
Thermador messages, symptoms, parts, repair visits
E9001 means the house power supply to the dishwasher is too low. Reset the breaker for 30 seconds; if E9001 comes back, have an electrician check the incoming voltage. The guide says E:90-01 is no problem with the appliance.
For a Thermador dishwasher that leaves water behind, the error-code page lists the same four steps for E22, E24 and E25: filter, drain pump cover, drain hose and air gap or hose. The DWHD660EFM guide adds two checks for a display reading E:61-03: remove the garbage disposal plug and keep a high loop in the hose.
Book a diagnostic made for your exact model and performed at the appliance itself.
Where the offices are, and what to tell us about getting in.