What it means
E9001 means the house power supply to the dishwasher is too low. Reset the breaker for 30 seconds; if E9001 comes back, have an electrician check the incoming voltage. The guide says E:90-01 is no problem with the appliance.
Thermador dishwasher E9001 / Water and power supply
E9001 means the house power supply to the dishwasher is too low. Reset the breaker for 30 seconds; if E9001 comes back, have an electrician check the incoming voltage. The guide says E:90-01 is no problem with the appliance.
Also appears as E9001
E9001 means the house power supply to the dishwasher is too low. Reset the breaker for 30 seconds; if E9001 comes back, have an electrician check the incoming voltage. The guide says E:90-01 is no problem with the appliance.
Off for 30 seconds, then on.
E9001 returns after the reset.
Your Thermador steps, stored on this device only

Off for 30 seconds, then on.

If it returns, the supply is the likely source.

Have the power voltage and the electrical installation checked.

Then the dishwasher gets a closer look.
Give us your model number and the checks you already made, then start your request below.
Book a visit
A simplified drawing, since the layout shifts from one model to the next. Tap any outlined part for its photo and the check that goes with it.
The guide says no: the power voltage is too low and there is no problem with the appliance.
Read the supporting manualThe incoming voltage and the electrical installation.
Read the supporting manualBoth report low supply voltage in different display styles.
Read the supporting manualManufacturer document
Thermador / BSH Home Appliances (thermador.com/us support page)
Undated web page; fetched 12.11.2026 / entry "E9001"
Manufacturer document
BSH Home Appliances Corporation (Thermador US manual PDF, media3.bsh-group.com)
PDF created 05.08.2026; file tag _C (no printed edition date read) / PDF p33-35 (troubleshooting table)
Sources: the Thermador dishwasher error-code page and the DWHD660EFM guide (E:90-01).
A reset can clear a one-off drop in supply voltage, so turn the breaker off for 30 seconds and back on. A repeat points to the supply, and then an electrician should check it.
Yes, the guide prints that spelling of the same code, and says the power voltage is too low and that there is no problem with the appliance.
The sources do not say. E27 describes low supply voltage on a different display style, but nothing printed links either code to other appliances.
Book with us after the electrician finds nothing wrong with the supply, because then the dishwasher gets a closer look.
Thermador messages, symptoms, parts, repair visits
E27 means the supply voltage is too low. Thermador adds that this is not a failure of the dishwasher itself; have your home's voltage and electrical system checked by a professional electrician.
For a Thermador dishwasher that leaves water behind, the error-code page lists the same four steps for E22, E24 and E25: filter, drain pump cover, drain hose and air gap or hose. The DWHD660EFM guide adds two checks for a display reading E:61-03: remove the garbage disposal plug and keep a high loop in the hose.
Book a diagnostic made for your exact model and performed at the appliance itself.
Where the offices are, and what to tell us about getting in.