Model-specific code library

Thermador dishwasher Control board and sensors codes

9 printed codes in this group: E0100, E0103, E0105, E0106, E0107, E0110, E04, E6900, E8000.

Dishwasher with the toe-kick panel off, exposing a control board in a white housing, and its three-prong power plug lying unplugged on the floor.
Experienced techniciansWarranty on our workmanshipOEM parts available on orderUpfront pricing, agreed before work

Control board and sensors codes

E0100

E0100 on a Thermador dishwasher reports a problem in the heat pump motor circuit on the main control board. Switch the dishwasher's breaker off for 30 seconds and back on; if the message stays, a technician is needed.

Reset once, then book
E0103

E0103 means a relay on the main control board of a Thermador dishwasher has a problem. Reset power at the breaker for 30 seconds; if the message stays, call for a technician.

Reset once, then book
E0105

E0105 is the four-digit form of a self-test result: the dishwasher found a problem in its heater electronics. The Thermador manual prints no owner step. Note the display and the model, then book a visit.

Book a visit
E0106

E0106 means the circuit that drives the wash arm diverter on the main control board has a problem. Reset power at the breaker for 30 seconds; if E0106 returns, book a technician.

Reset once, then book
E0107

E0107 carries the same relay message as E0103: a relay on the main control board has a problem. Reset the breaker for 30 seconds; if it persists, a technician is next.

Reset once, then book
E0110

E0110 means a failure is causing the electronics to miscommunicate. Thermador's page lists no owner step; note the display and model, and book a visit.

Book a visit
E04

E04 is the short form of the heater electronics self-test message on a Thermador dishwasher. The Thermador manual prints no owner step; note the display and model and book a visit.

Book a visit
E6900

E6900 means the detergent dispenser solenoid circuit has a problem. Switch the dishwasher's breaker off for 30 seconds and on again; if it returns, book a technician.

Reset once, then book
E8000

E8000 means the door sensor circuit has a problem. Close the door firmly, then switch the breaker off for 30 seconds and on again; if it returns, book a technician.

Reset once, then book

Let’s take care of it.

One burner, two burners,
or the whole range.