What it means
E0107 carries the same relay message as E0103: a relay on the main control board has a problem. Reset the breaker for 30 seconds; if it persists, a technician is next.
Thermador dishwasher E0107 / Control board and sensors
E0107 carries the same relay message as E0103: a relay on the main control board has a problem. Reset the breaker for 30 seconds; if it persists, a technician is next.
Also appears as E0107
E0107 carries the same relay message as E0103: a relay on the main control board has a problem. Reset the breaker for 30 seconds; if it persists, a technician is next.
Make sure it is E0107, not E0103.
E0107 returns after the reset.
Your Thermador steps, stored on this device only

Make sure it is E0107, not E0103.

Off for 30 seconds, then on.

See if the message stays away.

Relay problems need tools.
Give us your model number and the checks you already made, then start your request below.
Book a visitA simplified drawing, since the layout shifts from one model to the next. Tap any outlined part for its photo and the check that goes with it.

Component reference
The main control board runs a Thermador dishwasher's circuits.
Read the definitionThe Thermador manual prints separate entries, E0103 and E0107, with identical wording. It does not say what separates them.
Read the supporting manualThe sources do not rank them.
Read the supporting manualIt is the only step the manual gives.
Read the supporting manualManufacturer document
Thermador / BSH Home Appliances (thermador.com/us support page)
Undated web page; fetched 12.11.2026 / entry "E0107"
Source: the dishwasher error-code page from Thermador, entry E0107.
On the Thermador manual, yes. E0103 and E0107 print identical relay wording in separate entries, and the sources do not say what separates them.
That is not an owner decision. The Thermador manual says only that a relay on the main control board has a problem, and the board is a job for a technician.
30 seconds. Switch the breaker off for that long, then back on, and run a short cycle to see whether the message stays away.
Book a visit if E0107 keeps coming back after the 30-second reset. Check the display first to be sure it reads E0107, not E0103.
Thermador messages, symptoms, parts, repair visits
E0103 means a relay on the main control board of a Thermador dishwasher has a problem. Reset power at the breaker for 30 seconds; if the message stays, call for a technician.
For a Thermador dishwasher that leaves water behind, the error-code page lists the same four steps for E22, E24 and E25: filter, drain pump cover, drain hose and air gap or hose. The DWHD660EFM guide adds two checks for a display reading E:61-03: remove the garbage disposal plug and keep a high loop in the hose.
The main control board runs a Thermador dishwasher's circuits. Thermador's page names it in E0100, E0103, E0106 and E0107, and E0110 describes electronics that miscommunicate. For the first four it asks for the breaker to stay open for 30 seconds.
Book a diagnostic made for your exact model and performed at the appliance itself.
Where the offices are, and what to tell us about getting in.