Inside the appliance
Dishwasher main control board. In plain English.
The main control board runs a Thermador dishwasher's circuits. Thermador's page names it in E0100, E0103, E0106 and E0107, and E0110 describes electronics that miscommunicate. For the first four it asks for the breaker to stay open for 30 seconds.

Where it fits.
Dishwasher main control board in the appliance
Thermador's pages do not say where the board sits. It is inside the dishwasher and is reached by a technician.
The picture stands for a type of component. Which replacement suits your model is a separate question.
What shifts when this system needs a look.
Dishwasher main control board concerns may show up next to a drop in performance or a message that keeps returning. Testing comes before any verdict on the component.
Owner care, within the model instructions.
Turn the appliance off and pull the plug before doing any check yourself. Look out for standing water and sharp edges. Never handle a wet plug, remove a service panel or step beyond what your model's guide permits an owner.
- 1
Write down the code
E0100 is a heat pump motor circuit, E0106 a wash arm diverter circuit, E0103 and E0107 relay entries.
- 2
Cycle the breaker
Thermador's single step: flip the breaker to off, count 30 seconds, flip it back.
- 3
Leave the board alone
Thermador prints no board repair step. Our technician tests the board and the circuits it drives on site.
Cleaning or replacement?
Leave internal testing to a technician.
E0100, E0103, E0106 or E0107 is still there after the breaker has been toggled.
E0110 shows; the page lists no owner step.
Arrange a diagnosticSources and model boundaries.
These documents back up the Dishwasher main control board guidance. Choose the manual written for your model.
- Error Codes | Dishwashers Support | Thermador
- Error Codes | Dishwashers Support | Thermador
- Error Codes | Dishwashers Support | Thermador
Match your model to the guide it shipped with. See how we research these pages.
Which codes involve the control board?
E0100, E0103, E0106 and E0107 name it. E0110 describes a failure causing electronics miscommunication.
Will a reset clear them?
The page suggests a short pause without power, and says to get help if the code stays.
Does Thermador list a part price?
Not on the page. Our technician talks about parts only after testing, and no order goes out without your yes.
When should I book?
When the identical code is on the display again after that half-minute pause.
Thermador messages, symptoms, parts, repair visits
Move from the message to your next step.
E0100
E0100 on a Thermador dishwasher reports a problem in the heat pump motor circuit on the main control board. Switch the dishwasher's breaker off for 30 seconds and back on; if the message stays, a technician is needed.
Thermador dishwasher not draining
For a Thermador dishwasher that leaves water behind, the error-code page lists the same four steps for E22, E24 and E25: filter, drain pump cover, drain hose and air gap or hose. The DWHD660EFM guide adds two checks for a display reading E:61-03: remove the garbage disposal plug and keep a high loop in the hose.
Dishwasher repair
Book a diagnostic made for your exact model and performed at the appliance itself.
Find your metro
Where the offices are, and what to tell us about getting in.

