What it means
E0110 means a failure is causing the electronics to miscommunicate. Thermador's page lists no owner step; note the display and model, and book a visit.
Thermador dishwasher E0110 / Control board and sensors
E0110 means a failure is causing the electronics to miscommunicate. Thermador's page lists no owner step; note the display and model, and book a visit.
Also appears as E0110
E0110 means a failure is causing the electronics to miscommunicate. Thermador's page lists no owner step; note the display and model, and book a visit.
Copy the code and the model.
E0110 appears.
Your Thermador steps, stored on this device only

Copy the code and the model.

The Thermador manual gives no reset.

Do not open any panels.

A technician checks the communication between boards.
Give us your model number and the checks you already made, then start your request below.
Book a visit
A simplified drawing, since the layout shifts from one model to the next. Tap any outlined part for its photo and the check that goes with it.
The Thermador manual says electronics fail to communicate, without naming boards or parts.
Read the supporting manualE0100 has a breaker reset; E0110 has none.
Read the supporting manualOnly record the details.
Read the supporting manualThe manual lists no owner step for E0110, and the DWHD660EFM guide does not list the code either. For a case where all indicators light or flash because the electronics detected a failure, it says to press the main switch button for about 4 seconds, and the appliance resets and restarts.
Read the supporting manualManufacturer document
Thermador / BSH Home Appliances (thermador.com/us support page)
Undated web page; fetched 12.11.2026 / entry "E0110"
Manufacturer document
BSH Home Appliances Corporation (Thermador US manual PDF, media3.bsh-group.com)
PDF created 05.08.2026; file tag _C (no printed edition date read) / PDF p35
Source: the dishwasher error-code page from Thermador, entry E0110. The DWHD660EFM guide does not list this code; it is cited only for its general electronics reset.
The Thermador manual does not say. It reports a failure causing the electronics to miscommunicate, without naming a wire, board or part.
It is not listed. The Thermador manual gives no reset for E0110, unlike E0100, which has a breaker reset, so note the details and book a visit.
Not stated. The Thermador manual gives no warning and no owner step, so avoid repeated resets and book a visit rather than waiting.
The code, the model and the symptoms, meaning what the dishwasher did when E0110 appeared.
The Thermador manual says only that a failure is causing the electronics to miscommunicate. It names no board, wire or part, so only a technician's test can say where the problem sits.
Thermador messages, symptoms, parts, repair visits
E0100 on a Thermador dishwasher reports a problem in the heat pump motor circuit on the main control board. Switch the dishwasher's breaker off for 30 seconds and back on; if the message stays, a technician is needed.
For a Thermador dishwasher that leaves water behind, the error-code page lists the same four steps for E22, E24 and E25: filter, drain pump cover, drain hose and air gap or hose. The DWHD660EFM guide adds two checks for a display reading E:61-03: remove the garbage disposal plug and keep a high loop in the hose.
Book a diagnostic made for your exact model and performed at the appliance itself.
Where the offices are, and what to tell us about getting in.