What it means
E8000 means the door sensor circuit has a problem. Close the door firmly, then switch the breaker off for 30 seconds and on again; if it returns, book a technician.
Thermador dishwasher E8000 / Control board and sensors
E8000 means the door sensor circuit has a problem. Close the door firmly, then switch the breaker off for 30 seconds and on again; if it returns, book a technician.
Also appears as E8000
E8000 means the door sensor circuit has a problem. Close the door firmly, then switch the breaker off for 30 seconds and on again; if it returns, book a technician.
Check that nothing in the racks stops the door seating.
E8000 returns after the reset.
Your Thermador steps, stored on this device only

Check that nothing in the racks stops the door seating.

Off for 30 seconds, then on.

Watch whether it begins.

The sensor circuit needs a technician.
Give us your model number and the checks you already made, then start your request below.
Book a visit
A simplified drawing, since the layout shifts from one model to the next. Tap any outlined part for its photo and the check that goes with it.
A problem in the circuit of the door sensor.
Read the supporting manualThe leak codes are E15 and E3100, about water in the base. E8000 is about the door.
Read the supporting manualThe Thermador manual speaks of the sensor circuit, not the latch.
Read the supporting manualThe DWHD660EFM guide has protection against unintentional operation: after you start a program, the door must be closed within 4 seconds or the program pauses until you press the start button and close the door.
Read the supporting manualManufacturer document
Thermador / BSH Home Appliances (thermador.com/us support page)
Undated web page; fetched 12.11.2026 / entry "E8000"
Manufacturer document
BSH Home Appliances Corporation (Thermador US manual PDF, media3.bsh-group.com)
PDF created 05.08.2026; file tag _C (no printed edition date read) / PDF p26
Source: the Thermador dishwasher error-code page, entry E8000. The DWHD660EFM guide describes the door closing rule; it does not list E8000.
A rack or dish sticking out can keep the door from closing.
Keep the breaker off for 30 seconds, then switch it back on. Book a technician if E8000 returns.
Stop using it if cycles do not start. A door sensor circuit problem can keep the dishwasher from running.
Give the code, the model, and whether the door clicks shut. That helps the technician check the door sensor circuit.
Thermador messages, symptoms, parts, repair visits
E6900 means the detergent dispenser solenoid circuit has a problem. Switch the dishwasher's breaker off for 30 seconds and on again; if it returns, book a technician.
For a Thermador dishwasher that leaves water behind, the error-code page lists the same four steps for E22, E24 and E25: filter, drain pump cover, drain hose and air gap or hose. The DWHD660EFM guide adds two checks for a display reading E:61-03: remove the garbage disposal plug and keep a high loop in the hose.
Book a diagnostic made for your exact model and performed at the appliance itself.
Where the offices are, and what to tell us about getting in.