What it means
E3200 reports an issue with water flowing into the dishwasher: the level is too low or water is not pumped correctly. Check the inlet hose, confirm the supply is on (10 l/min), then see the DWHD660EFM guide.
Thermador dishwasher E3200 / Water and power supply
E3200 reports an issue with water flowing into the dishwasher: the level is too low or water is not pumped correctly. Check the inlet hose, confirm the supply is on (10 l/min), then see the DWHD660EFM guide.
Also appears as E3200
E3200 reports an issue with water flowing into the dishwasher: the level is too low or water is not pumped correctly. Check the inlet hose, confirm the supply is on (10 l/min), then see the DWHD660EFM guide.
Look for kinks or damage along its length.
E3200 keeps coming back although the hose is clear and the valve open.
Your Thermador steps, stored on this device only

Look for kinks or damage along its length.

Make sure the water supply to the dishwasher is turned on.

The Thermador manual says the water flow rate should be 10 l/min.

If hose and supply are fine, a technician tests the fill and pump.
Give us your model number and the checks you already made, then start your request below.
Book a visit
A simplified drawing, since the layout shifts from one model to the next. Tap any outlined part for its photo and the check that goes with it.
The water level is too low, or water is not being pumped as it should be.
Read the supporting manualNear-identical wording in the four-digit style; E18 is the shorter form.
Read the supporting manualThe DWHD660EFM guide has a troubleshooting table on pages 33 to 35.
Read the supporting manualManufacturer document
Thermador / BSH Home Appliances (thermador.com/us support page)
Undated web page; fetched 12.11.2026 / entry "E3200"
Manufacturer document
BSH Home Appliances Corporation (Thermador US manual PDF, media3.bsh-group.com)
PDF created 05.08.2026; file tag _C (no printed edition date read) / PDF p33-35 (troubleshooting table)
Sources: the Thermador dishwasher error-code page and the DWHD660EFM guide, pp. 33 to 35.
The flow rate figure in the Thermador manual suggests supply is a factor.
Yes, the Thermador manual lists the inlet hose first.
Check, because a half-closed tap lowers the flow.
Book a visit if the inlet hose and the water supply both check out and E3200 comes back. The DWHD660EFM guide covers those two checks.
Thermador messages, symptoms, parts, repair visits
E18 means the water level is too low or water is not being pumped properly. Start with the inlet hose and look for kinks, then confirm the water supply is on; the Thermador manual gives 10 l/min as the flow rate.
For a Thermador dishwasher that leaves water behind, the error-code page lists the same four steps for E22, E24 and E25: filter, drain pump cover, drain hose and air gap or hose. The DWHD660EFM guide adds two checks for a display reading E:61-03: remove the garbage disposal plug and keep a high loop in the hose.
Book a diagnostic made for your exact model and performed at the appliance itself.
Where the offices are, and what to tell us about getting in.