What it means
E7015 means the electronics of a Thermador induction cooktop overheated and the related cooking zone was switched off. Wait for the electronics to cool, touch a control, and cook again once the message is gone.
Thermador cooktop E7015 / Overheating
E7015 means the electronics of a Thermador induction cooktop overheated and the related cooking zone was switched off. Wait for the electronics to cool, touch a control, and cook again once the message is gone.
Also appears as E7015
E7015 means the electronics of a Thermador induction cooktop overheated and the related cooking zone was switched off. Wait for the electronics to cool, touch a control, and cook again once the message is gone.
The related zone has already shut off; do not restart it at once.
The same code returns after cooling.
Your Thermador steps, stored on this device only

The related zone has already shut off; do not restart it at once.

The Thermador manual asks you to wait until the electronics have cooled down sufficiently.

This clears the display once the electronics have cooled.

Continue cooking once the message has disappeared.
Give us your model number and the checks you already made, then start your request below.
Book a visit
A simplified drawing, since the layout shifts from one model to the next. Tap any outlined part for its photo and the check that goes with it.

Component reference
The electronics of a Thermador cooktop or range cooktop run the zones and protect themselves from overheating.
Read the definitionThermador groups F2, F4, E7015, E8207 and E8208 under one overheating entry with identical steps.
Read the supporting manualThe ranges page pairs E7015 with F2 (one zone off) and again with F4 (all zones off), so the induction cooktop entry and the range entries are not word-for-word the same.
Read the supporting manualIt is a protection shutdown. Repeated shutdowns after proper cooling are the case for a visit.
Read the supporting manualManufacturer document
Thermador / BSH Home Appliances (thermador.com/us support page)
Undated web page; fetched 12.11.2026 / entry "F2, F4, E7015, E8207, E8208"
Sources: Thermador induction cooktop and range error-code pages. The induction page groups five codes; the range page splits some.
The Thermador manual gives no minutes, only until the electronics have cooled down sufficiently.
The sources for this entry do not name cookware as a cause.
The wording is about the related zone, not all of them.
Book a visit when E7015 keeps returning even after the electronics have cooled. A single message that clears after cooling does not call for one.
Thermador messages, symptoms, parts, repair visits
F1 on a Thermador induction cooktop means a cooking zone overheated and switched itself off to protect the work surface. Give the electronics time to cool down before you turn the zone back on.
When one Thermador burner will not light while the rest do, the support page points to the burner cap: it is out of alignment, and its tabs must sit in the notches on the burner base. The cooktop guide adds a 4-second rule and clean, dry igniter ports. Gas odor means shut the unit off and book a visit.
The electronics of a Thermador cooktop or range cooktop run the zones and protect themselves from overheating. F2 means the electronics overheated and one zone shut off; F4 shuts all zones; E7015, E8207 and E8208 are listed with them. Wait for the electronics to cool, then touch any control.
Book a diagnostic made for your exact model and performed at the appliance itself.
Where the offices are, and what to tell us about getting in.