What it means
F1 on a Thermador induction cooktop means a cooking zone overheated and switched itself off to protect the work surface. Give the electronics time to cool down before you turn the zone back on.
Thermador cooktop F1 / Overheating
F1 on a Thermador induction cooktop means a cooking zone overheated and switched itself off to protect the work surface. Give the electronics time to cool down before you turn the zone back on.
Also appears as F1
F1 on a Thermador induction cooktop means a cooking zone overheated and switched itself off to protect the work surface. Give the electronics time to cool down before you turn the zone back on.
Lift the cookware off the zone that shut down.
F1 returns after cooling.
Your Thermador steps, stored on this device only

Lift the cookware off the zone that shut down.

The Thermador manual asks you to wait until they have cooled down sufficiently.

Turn the zone back on and carry on cooking.

Note which zone it was and what you were cooking if the message returns.
Give us your model number and the checks you already made, then start your request below.
Book a visit

A simplified drawing, since the layout shifts from one model to the next. Tap any outlined part for its photo and the check that goes with it.
The cooking zone itself, according to Thermador. The shutdown protects the work surface, not the electronics.
Read the supporting manualF2 and F4 report overheated electronics; F1 and F6 report an overheated zone. The remedy has a similar shape but a different cause.
Read the supporting manualThermador prints them as one entry with identical steps.
Read the supporting manualManufacturer document
Thermador / BSH Home Appliances (thermador.com/us support page)
Undated web page; fetched 12.11.2026 / entry "F1 or F6"
Source: the Thermador induction cooktop error-code page, entry F1 or F6.
No time is given. Wait until the electronics have cooled sufficiently.
The shutdown is described as protection for it, and the Thermador manual reports no damage.
The wording concerns the one zone that shut off.
If the same zone shuts down again after cooling.
Thermador messages, symptoms, parts, repair visits
F6 means a cooking zone overheated and shut itself off to protect the work surface, in the same wording Thermador uses for F1. Wait for the electronics to cool, then switch the zone back on.
When one Thermador burner will not light while the rest do, the support page points to the burner cap: it is out of alignment, and its tabs must sit in the notches on the burner base. The cooktop guide adds a 4-second rule and clean, dry igniter ports. Gas odor means shut the unit off and book a visit.
Book a diagnostic made for your exact model and performed at the appliance itself.
Where the offices are, and what to tell us about getting in.