Inside the appliance
Cooktop cooling fan and fan input. In plain English.
A Thermador Freedom induction cooktop has a cooling fan on its underside. The use and care guide warns that materials sucked into the fan can reduce cooling or damage it, and asks for at least 3/4 inch (20 mm) between a drawer's contents and the fan input when the cooktop is above a drawer.

Where it fits.
Cooktop cooling fan and fan input in the appliance
On the underside of the cooktop, where the guide places the fan and its input.
The picture stands for a type of component. Which replacement suits your model is a separate question.
What shifts when this system needs a look.
Cooktop cooling fan and fan input concerns may show up next to a drop in performance or a message that keeps returning. Testing comes before any verdict on the component.

Thermador gas burner won't light
When one Thermador burner will not light while the rest do, the support page points to the burner cap: it is out of alignment, and its tabs must sit in the notches on the burner base. The cooktop guide adds a 4-second rule and clean, dry igniter ports. Gas odor means shut the unit off and book a visit.

Thermador gas igniter keeps clicking
Thermador's page lists four causes for sparking that will not stop or starts with the cooktop off: knobs left in the lighting or spark position, a draft working on the re-ignition feature, water on the surface, or a knob held down past the child lock position. Dismantling a gas appliance is a job for a trained technician.
Owner care, within the model instructions.
Turn the appliance off and pull the plug before doing any check yourself. Look out for standing water and sharp edges. Never handle a wet plug, remove a service panel or step beyond what your model's guide permits an owner.
- 1
Empty the drawer below
The guide says a drawer under the cooktop must not contain objects or paper.
- 2
Keep 3/4 inch clear
Keep a minimum of 3/4 in (20 mm) between the drawer's contents and the fan input.
- 3
Watch for overheating messages
F2, F4 and E7015 mean the electronics overheated. Wait for them to cool, then touch any control.
- 4
Reset if it behaves oddly
For an unusual response, disconnect power, wait a couple of seconds and reconnect.
- 5
Do not operate a damaged cooktop
The guide says not to run the appliance if it is not working properly or has been damaged.
Cleaning or replacement?
Leave internal testing to a technician.
Overheating messages return with a clear drawer below.
The cooktop behaves unusually after the power reset.
Something has been drawn into the fan.
Arrange a diagnosticSources and model boundaries.
These documents back up the Cooktop cooling fan and fan input guidance. Choose the manual written for your model.
- Use and care guide, Freedom Induction cooktop CIT36YWB CIT36YWBB (en-us)
- Error Codes | Induction Cooktops Support | Thermador
Match your model to the guide it shipped with. See how we research these pages.
Does my Thermador cooktop have a fan?
The Freedom induction cooktop guide says it has a cooling fan on its underside. Check your own model's guide.
What can damage the fan?
Materials sucked into it. The guide says to keep objects and paper out of a drawer below the cooktop.
How much clearance does the fan need?
At least 3/4 in (20 mm) between the contents of a drawer below and the fan input, per the guide.
What do F2 and F4 mean?
The electronics overheated and a cooking zone (F2) or all zones (F4) switched off. Wait for cooling and touch any control.
Can I clean the fan myself?
The guide gives no fan cleaning steps and says other servicing is for service providers. Book a visit if you suspect a blockage.
Thermador messages, symptoms, parts, repair visits
Move from the message to your next step.
F2
F2 on a Thermador electric cooktop means the electronics overheated and the related cooking zone was switched off. Wait until the electronics cool, then touch any control.
Thermador gas burner won't light
When one Thermador burner will not light while the rest do, the support page points to the burner cap: it is out of alignment, and its tabs must sit in the notches on the burner base. The cooktop guide adds a 4-second rule and clean, dry igniter ports. Gas odor means shut the unit off and book a visit.
Cooktop repair
Book a diagnostic made for your exact model and performed at the appliance itself.
Find your metro
Where the offices are, and what to tell us about getting in.
