What it means
F2 on a Thermador electric cooktop means the electronics overheated and the related cooking zone was switched off. Wait until the electronics cool, then touch any control.
Thermador cooktop F2 / Overheating
F2 on a Thermador electric cooktop means the electronics overheated and the related cooking zone was switched off. Wait until the electronics cool, then touch any control.
Also appears as F2
F2 on a Thermador electric cooktop means the electronics overheated and the related cooking zone was switched off. Wait until the electronics cool, then touch any control.
Do not restart the zone straight away.
F2 returns after cooling.
Your Thermador steps, stored on this device only

Do not restart the zone straight away.

Wait until the electronics have cooled down sufficiently.

Touch any control on the cooktop.

Carry on when the message has gone.
Give us your model number and the checks you already made, then start your request below.
Book a visit
A simplified drawing, since the layout shifts from one model to the next. Tap any outlined part for its photo and the check that goes with it.

Component reference
The electronics of a Thermador cooktop or range cooktop run the zones and protect themselves from overheating.
Read the definitionAn electronics overheating message for one cooking zone.
Read the supporting manualOn the electric page F4 shuts down every zone, while F2 shuts down only the matching one.
Read the supporting manualThe induction page lists F2 in a group with four other codes. The electric page lists it alone.
Read the supporting manualNo manual for Thermador electric cooktops is cached for this site, so the closest printed match is the Freedom induction guide. Its row for a cooking zone that switched off automatically lists two causes: overheated electronics, and hot cookware near the control panel.
Read the supporting manualManufacturer document
Thermador / BSH Home Appliances (thermador.com/us support page)
Undated web page; fetched 12.11.2026 / entry "F2"
Manufacturer document
BSH Home Appliances Corporation (Thermador US manual PDF, media3.bsh-group.com)
PDF created 25.09.2026; file tag _H (no printed edition date read) / PDF p32
Source: the error-code page for Thermador electric cooktops, entry F2. No electric cooktop manual is cached; the Freedom induction cooktop guide uses the same wording.
No, Thermador blames overheated electronics for F2, not a bad zone. The related cooking zone is switched off until things cool.
F2 is worded for the corresponding zone only.
Wait until the electronics are sufficiently cool, then touch any control. Thermador prints no set time.
Book a visit and tell the technician which zone was switched off. Say that F2 came back after cooling.
Yes, per the Freedom induction guide: cookware near the control panel can switch a zone off to protect the electronics. The electric page lists that case separately under F5 and a signal tone.
Thermador messages, symptoms, parts, repair visits
F4 on a Thermador electric cooktop means the electronics overheated and all cooking zones switched off. Wait for the electronics to cool, then touch any control.
When one Thermador burner will not light while the rest do, the support page points to the burner cap: it is out of alignment, and its tabs must sit in the notches on the burner base. The cooktop guide adds a 4-second rule and clean, dry igniter ports. Gas odor means shut the unit off and book a visit.
The electronics of a Thermador cooktop or range cooktop run the zones and protect themselves from overheating. F2 means the electronics overheated and one zone shut off; F4 shuts all zones; E7015, E8207 and E8208 are listed with them. Wait for the electronics to cool, then touch any control.
Book a diagnostic made for your exact model and performed at the appliance itself.
Where the offices are, and what to tell us about getting in.