What it means
F5 alternating with the power level and a tone on a Thermador induction cooktop warns that hot cookware sits near the control panel. Remove it from the panel and you can keep cooking.
Thermador cooktop F5 and power level flashing with signal tone / Overheating
F5 alternating with the power level and a tone on a Thermador induction cooktop warns that hot cookware sits near the control panel. Remove it from the panel and you can keep cooking.
Also appears as F5 and power level flashing with signal tone
F5 alternating with the power level and a tone on a Thermador induction cooktop warns that hot cookware sits near the control panel. Remove it from the panel and you can keep cooking.
Find any hot pot near the controls.
F5 returns with nothing near the control panel.
Your Thermador steps, stored on this device only

Find any hot pot near the controls.

Move the cookware off the panel area.

The alternating display should clear.

If F5 flashes with nothing near the panel, book a visit.
Give us your model number and the checks you already made, then start your request below.
Book a visit
A simplified drawing, since the layout shifts from one model to the next. Tap any outlined part for its photo and the check that goes with it.

Component reference
The control panel on a Thermador Freedom induction cooktop has touch keys and a touchscreen.
Read the definition
Component reference
The electronics of a Thermador cooktop or range cooktop run the zones and protect themselves from overheating.
Read the definitionHot cookware near the control panel, with the electronics at risk of overheating.
Read the supporting manualNot at this stage; Thermador describes a separate F5 with a tone in which the zone has already switched off.
Read the supporting manualThe induction wording is the power level flashing alternately with F5. The electric page words it with the heat level.
Read the supporting manualManufacturer document
Thermador / BSH Home Appliances (thermador.com/us support page)
Undated web page; fetched 12.11.2026 / entry "F5 and the power level flashes alternately with a signal tone"
Source: the error-code page for Thermador induction cooktops, entry F5 and the power level flashes alternately with a signal tone.
The Thermador manual pairs the tone with the flashing F5 as one warning that hot cookware sits near the control panel and the electronics are at risk of overheating.
Yes, after removing the cookware from the control panel area. This F5 is a warning; the zone has not switched off.
Not according to the Thermador manual. It names hot cookware near the panel as the trigger, so book a visit only if F5 flashes with nothing nearby.
The Thermador manual names hot cookware near the panel only, with no list of pans. Move any hot pot or pan off the panel area and keep it away from the controls.
Thermador messages, symptoms, parts, repair visits
When one Thermador burner will not light while the rest do, the support page points to the burner cap: it is out of alignment, and its tabs must sit in the notches on the burner base. The cooktop guide adds a 4-second rule and clean, dry igniter ports. Gas odor means shut the unit off and book a visit.
The electronics of a Thermador cooktop or range cooktop run the zones and protect themselves from overheating. F2 means the electronics overheated and one zone shut off; F4 shuts all zones; E7015, E8207 and E8208 are listed with them. Wait for the electronics to cool, then touch any control.
Book a diagnostic made for your exact model and performed at the appliance itself.
Where the offices are, and what to tell us about getting in.