Before work starts
Your technician reviews the issue with you and settles the cost before any repair starts. For built-in units the final figure comes after an on-site look.
Independent appliance repair
Book a visit for a Thermador hood or downdraft with a lit FILTER light, a blower that will not start, a light that works with a dead motor or a rattling filter. Grease filters come first; the lights are reminders, not failures. Isolate power before any work above the cooktop.


Thermador’s hood guides blame weak venting on the installation more often than on the hood: it may sit too high or off-center, make-up air may be short, wind may be pushing in through an open window, or the duct may be blocked, too long or full of elbows. Close windows, clear the duct opening, then book a visit.

Some noise from a Thermador hood is normal, from vibration and moving air. Excessive noise points to the installation: ductwork that is undersized, oversized or loose, a loose transition, or screws not fully tight. Tighten what you can reach, and call us if the noise stays.
Part names come only after the technician has examined the hood in person. The quote comes first; nothing is ordered unless you agree.
What to expect.
Every step explained in advance.

Choose your appliance, whether range, oven or refrigeration, and tell us how it is behaving.

The technician inspects the unit, reviews the cause with you and agrees the cost before starting the work.

After the repair, the technician tests the appliance and explains the result, so you know what changed.
A lit FILTER icon asks for a clean. The Pro hood guide says hand-wash only; the support page allows an empty dishwasher, with slight discoloration.
Press and hold FILTER for 3 seconds until it beeps on professional hoods; downdrafts take a 2-second hold.
If the light works but the motor will not turn, Thermador says a thermal protection system may have shut it off. It restarts after cooling.
A vibrating grease filter is loose. Fit it properly to the grease tray.
The blower does not start after power and wiring are checked.
AUTO blinks 3 times again after the hood cooled.
The FILTER light returns right after a clean and reset.
Arrange a diagnosticYour technician reviews the issue with you and settles the cost before any repair starts. For built-in units the final figure comes after an on-site look.
Repairs under Thermador's manufacturer warranty belong with Thermador. For the work we carry out, we provide our own workmanship warranty.
On the downdraft the hood detected excessive heat, and the fan speeds up to protect components. Let the hood and cooking area cool down.
The blower runs on high for 10 minutes after you press DELAY. Wait for the time to pass.
CONNECT and a fan setting flash when Wi-Fi did not connect within 2 minutes. Restart the connection steps in the app.
If your hood is still inside the manufacturer's warranty, that coverage stays with the manufacturer. Once it has ended, we are glad to visit.
Thermador messages, symptoms, parts, repair visits
AUTO blinking 3 times on a Thermador downdraft hood means the hood detected excessive heat. The fan speeds up to protect components. Let the hood and the cooking area cool down.
Thermador’s hood guides blame weak venting on the installation more often than on the hood: it may sit too high or off-center, make-up air may be short, wind may be pushing in through an open window, or the duct may be blocked, too long or full of elbows. Close windows, clear the duct opening, then book a visit.
Grease filters catch cooking grease inside a Thermador hood. A FILTER light asks for a clean: after 40 hours on professional hoods, after 30 hours of blower time on the downdraft. The sources conflict on the dishwasher: the hood guide says hand-wash only, the support page allows an empty one.
Book a diagnostic made for your exact model and performed at the appliance itself.
Where the offices are, and what to tell us about getting in.