What it means
FILTER lit on a Thermador hood is a cleaning reminder after 40 hours of operation. Clean the filters, then press and hold FILTER for 3 seconds until it beeps.
Thermador hood FILTER lit / Filter reminders
FILTER lit on a Thermador hood is a cleaning reminder after 40 hours of operation. Clean the filters, then press and hold FILTER for 3 seconds until it beeps.
Also appears as FILTER lit
FILTER lit on a Thermador hood is a cleaning reminder after 40 hours of operation. Clean the filters, then press and hold FILTER for 3 seconds until it beeps.
Remove them following your hood guide.
FILTER stays lit after reset.
Your Thermador steps, stored on this device only

Remove them following your hood guide.

Follow the cleaning section.

Seat them properly.
Press and hold FILTER for 3 seconds until it beeps.
Give us your model number and the checks you already made, then start your request below.
Book a visit

A simplified drawing, since the layout shifts from one model to the next. Tap any outlined part for its photo and the check that goes with it.

Component reference
Grease filters catch cooking grease inside a Thermador hood.
Read the definitionAfter 40 hours of operation.
Read the supporting manualChimney, island, drawer, insert and Professional hoods.
Read the supporting manualDowndraft hoods blink the icon after 30 hours.
Read the supporting manualIt depends on the hood. The Professional Series guide says its filters are not dishwasher safe and must be hand washed in hot water with a mild detergent. The custom insert guide says its metal grease filter can go in the dishwasher or be washed by hand.
Read the supporting manualWhenever FILTER lights up or the filters collect grease. Over a grill, wok or other high-grease cooking, more frequent cleaning may be needed. The insert guide adds at least every two months, or as often as necessary.
Read the supporting manualManufacturer document
BSH Home Appliances Corporation (Thermador US manual PDF, media3.bsh-group.com)
PDF created 17.04.2023; file tag _A (no printed edition date read) / PDF p9
Manufacturer document
BSH Home Appliances Corporation (Thermador US manual PDF, media3.bsh-group.com)
PDF created 27.01.2021; file tag _A (no printed edition date read) / PDF p10
Sources: the use and care guides for the Thermador Professional Series hoods PH30HWS, PH36HWS, PH48HWS and the custom insert hoods, pp. 9 to 10.
It confirms the reset. Press and hold FILTER for 3 seconds until the hood beeps, after cleaning the filters and putting them back.
The reminder is advisory, but it is there because filters collect grease. Clean the filters whenever FILTER lights up or they collect grease.
Book a visit if FILTER stays lit after you have cleaned the filters, seated them properly and held FILTER for 3 seconds until the beep.
The guide ties the reminder to cleaning, which it asks for whenever FILTER lights up or the filters collect grease. It gives no airflow figures.
Thermador messages, symptoms, parts, repair visits
FILTER blinking on a Thermador downdraft hood is a cleaning reminder after 30 hours of blower run time. Clean the filter, then touch and hold the FILTER icon for 2 seconds or longer to reset it.
Thermador’s hood guides blame weak venting on the installation more often than on the hood: it may sit too high or off-center, make-up air may be short, wind may be pushing in through an open window, or the duct may be blocked, too long or full of elbows. Close windows, clear the duct opening, then book a visit.
Grease filters catch cooking grease inside a Thermador hood. A FILTER light asks for a clean: after 40 hours on professional hoods, after 30 hours of blower time on the downdraft. The sources conflict on the dishwasher: the hood guide says hand-wash only, the support page allows an empty one.
Book a diagnostic made for your exact model and performed at the appliance itself.
Where the offices are, and what to tell us about getting in.