Read the whole display
Say which hood series it is, and whether the signal is a lit button or a blinking icon.
Model-specific code library
We decode 6 Thermador range hood entries.
AUTO blinking 3 times on a Thermador downdraft hood means the hood detected excessive heat. The fan speeds up to protect components. Let the hood and the cooking area cool down.
Read the AUTO blinks 3 times checks6 researched hood codes. What a panel message means depends on the model, so rely on the manual that came with yours.
AUTO blinking 3 times on a Thermador downdraft hood means the hood detected excessive heat. The fan speeds up to protect components. Let the hood and the cooking area cool down.
Cool down, then bookCONNECT and the number 2 flashing on a Thermador hood means it could not make a Wi-Fi connection within 2 minutes. Start the connection steps again in the app.
Check firstDELAY lit on a Thermador hood means the delay shut-off is running: the blower stays on high for 10 minutes and then stops. Wait for the 10 minutes to pass.
InformationalFILTER blinking on a Thermador downdraft hood is a cleaning reminder after 30 hours of blower run time. Clean the filter, then touch and hold the FILTER icon for 2 seconds or longer to reset it.
InformationalFILTER lit on a Thermador hood is a cleaning reminder after 40 hours of operation. Clean the filters, then press and hold FILTER for 3 seconds until it beeps.
InformationalTwo short beeps from a Thermador hood mean a button press asked for something the hood cannot do. Check the button you pressed; hold FILTER and LIGHTS for 3 seconds to switch the control tone off or on.
Informational
We decode 6 Thermador range hood entries.
We read the downdraft hood guides (UCVM30XS, UCVM36XS, UCVP36XS), the Masterpiece custom insert and chimney guides, and the Professional Series guide. Filter reminders differ by series, so they are not merged.
Say which hood series it is, and whether the signal is a lit button or a blinking icon.
Let the hood and cooking area cool before you handle filters.
Thermador’s hood guides blame weak venting on the installation more often than on the hood: it may sit too high or off-center, make-up air may be short, wind may be pushing in through an open window, or the duct may be blocked, too long or full of elbows. Close windows, clear the duct opening, then book a visit.
Some noise from a Thermador hood is normal, from vibration and moving air. Excessive noise points to the installation: ductwork that is undersized, oversized or loose, a loose transition, or screws not fully tight. Tighten what you can reach, and call us if the noise stays.
Match your model to the guide it shipped with. See how we research these pages.
We read the downdraft hood guides (UCVM30XS, UCVM36XS, UCVP36XS), the Masterpiece custom insert and chimney guides, and the Professional Series guide. Filter reminders differ by series, so they are not merged.
Photograph the entire hood panel along with the rating plate. Note what the appliance was doing when the message came up, and do not lean on the explanation for a different unit.
A phrase people once typed into a search box is not evidence from the manufacturer. When our hood manuals leave a message unexplained, we print its name, send you toward help and name no cause.
Open the Thermador manuals in this hood library and match the model printed on each cover to your rating plate. A different series comes with its own use-and-care guide.