What it means
CONNECT and the number 2 flashing on a Thermador hood means it could not make a Wi-Fi connection within 2 minutes. Start the connection steps again in the app.
Thermador hood CONNECT and 2 flashing / Connection
CONNECT and the number 2 flashing on a Thermador hood means it could not make a Wi-Fi connection within 2 minutes. Start the connection steps again in the app.
Also appears as CONNECT and 2 flashing
CONNECT and the number 2 flashing on a Thermador hood means it could not make a Wi-Fi connection within 2 minutes. Start the connection steps again in the app.
Confirm the router is on and the signal reaches the hood.
The connection fails again.
Your Thermador steps, stored on this device only

Confirm the router is on and the signal reaches the hood.

Begin the connection process in the app again.

CONNECT and a fan setting flash while it connects.
Repeated failures after a good Wi-Fi check call for a visit.
Give us your model number and the checks you already made, then start your request below.
Book a visit


A simplified drawing, since the layout shifts from one model to the next. Tap any outlined part for its photo and the check that goes with it.
The guide says the hood waits 2 minutes for a connection before showing the flashing CONNECT.
Read the supporting manualThe guide ties the message to connection, not extraction.
Read the supporting manualNo.
Read the supporting manualManufacturer document
BSH Home Appliances Corporation (Thermador US manual PDF, media3.bsh-group.com)
PDF created 27.01.2021; file tag _A (no printed edition date read) / PDF p13
Manufacturer document
BSH Home Appliances Corporation (Thermador US manual PDF, media3.bsh-group.com)
PDF created 09.06.2018; file tag _A (no printed edition date read) / PDF p13
Sources: the use and care guides for the Thermador Masterpiece custom insert hoods VCI3B30ZS, VCI3B36ZS and VCI6B30Z, and the chimney wall hoods, p. 13.
Yes, the connection steps are carried out in the app. Start them again after the 2-minute attempt ends.
Not necessarily; the Thermador manual only says the hood could not connect.
The message is about connection, so the hood's own controls are not affected in the guide's wording.
Book a visit if the Wi-Fi connection keeps failing after you repeat the steps in the app.
Thermador messages, symptoms, parts, repair visits
Thermador’s hood guides blame weak venting on the installation more often than on the hood: it may sit too high or off-center, make-up air may be short, wind may be pushing in through an open window, or the duct may be blocked, too long or full of elbows. Close windows, clear the duct opening, then book a visit.
Book a diagnostic made for your exact model and performed at the appliance itself.
Where the offices are, and what to tell us about getting in.