What it means
AUTO blinking 3 times on a Thermador downdraft hood means the hood detected excessive heat. The fan speeds up to protect components. Let the hood and the cooking area cool down.
Thermador hood AUTO blinks 3 times / Modes and messages
AUTO blinking 3 times on a Thermador downdraft hood means the hood detected excessive heat. The fan speeds up to protect components. Let the hood and the cooking area cool down.
Also appears as AUTO blinks 3 times
AUTO blinking 3 times on a Thermador downdraft hood means the hood detected excessive heat. The fan speeds up to protect components. Let the hood and the cooking area cool down.
Turn off or lower burners under or near the hood.
The auto icon keeps blinking after cooling.
Your Thermador steps, stored on this device only

Turn off or lower burners under or near the hood.

The blower speeds up on its own; leave it on.

Give the hood and the cooktop area time to cool.

If AUTO keeps blinking when everything is cool, book a visit.
Give us your model number and the checks you already made, then start your request below.
Book a visit

A simplified drawing, since the layout shifts from one model to the next. Tap any outlined part for its photo and the check that goes with it.

Component reference
A Thermador Professional hood uses a separate remote, in-line or integral blower.
Read the definitionThe hood detects excessive heat and blinks the AUTO icon three times.
Read the supporting manualIt speeds up to protect hood components.
Read the supporting manualFilter reminders blink FILTER after run-time hours. This one is a heat response.
Read the supporting manualManufacturer document
BSH Home Appliances Corporation (Thermador US manual PDF, media3.bsh-group.com)
PDF created 22.08.2019; file tag _A (no printed edition date read) / PDF p8
Manufacturer document
BSH Home Appliances Corporation (Thermador US manual PDF, media3.bsh-group.com)
PDF created 22.08.2019; file tag _A (no printed edition date read) / PDF p8
Sources: the use and care guides for the Thermador Masterpiece downdraft hoods UCVM30XS, UCVM36XS and UCVP36XS, p. 8.
No, it is a protective response. The hood speeds up its fan to protect its components from the excessive heat.
Thermador's guides covering this blinking apply to downdraft hoods. Other hood types are not mentioned.
The guide describes the fan response as the protection.
Book a visit if AUTO keeps blinking after the hood and cooking area have cooled.
Thermador messages, symptoms, parts, repair visits
FILTER blinking on a Thermador downdraft hood is a cleaning reminder after 30 hours of blower run time. Clean the filter, then touch and hold the FILTER icon for 2 seconds or longer to reset it.
Thermador’s hood guides blame weak venting on the installation more often than on the hood: it may sit too high or off-center, make-up air may be short, wind may be pushing in through an open window, or the duct may be blocked, too long or full of elbows. Close windows, clear the duct opening, then book a visit.
A Thermador Professional hood uses a separate remote, in-line or integral blower. DELAY keeps it running for 10 minutes after you finish cooking, then it stops. AUTO lets the hood watch the heat from the cooktop and turn the blower on and off, adjusting every 5 minutes. Only Thermador blowers should be used.
Book a diagnostic made for your exact model and performed at the appliance itself.
Where the offices are, and what to tell us about getting in.