What it means
Two short beeps from a Thermador hood mean a button press asked for something the hood cannot do. Check the button you pressed; hold FILTER and LIGHTS for 3 seconds to switch the control tone off or on.
Thermador hood Two short beeps / Modes and messages
Two short beeps from a Thermador hood mean a button press asked for something the hood cannot do. Check the button you pressed; hold FILTER and LIGHTS for 3 seconds to switch the control tone off or on.
Also appears as Two short beeps
Two short beeps from a Thermador hood mean a button press asked for something the hood cannot do. Check the button you pressed; hold FILTER and LIGHTS for 3 seconds to switch the control tone off or on.
Press the function you wanted again.
Beeps continue with no button pressed.
Your Thermador steps, stored on this device only

Press the function you wanted again.

The function may not be possible in the current state.

Hold FILTER and LIGHTS for 3 seconds.

The tone can also be changed in the Home Connect app.
Give us your model number and the checks you already made, then start your request below.
Book a visit


A simplified drawing, since the layout shifts from one model to the next. Tap any outlined part for its photo and the check that goes with it.
Buttons incorrectly pressed, or a function the system cannot perform.
Read the supporting manualYes, with a 3-second hold of FILTER and LIGHTS.
Read the supporting manualNo, it is a control tone.
Read the supporting manualThe Professional guide lists the controls: touching 0 turns the hood off and resets the control, and 1 to 4 set the fan speed from low to high. Resetting with 0 and then pressing one button at a time is a reasonable way to find which press gets the beeps.
Read the supporting manualManufacturer document
BSH Home Appliances Corporation (Thermador US manual PDF, media3.bsh-group.com)
PDF created 27.01.2021; file tag _A (no printed edition date read) / PDF p17
Manufacturer document
BSH Home Appliances Corporation (Thermador US manual PDF, media3.bsh-group.com)
PDF created 17.04.2023; file tag _A (no printed edition date read) / PDF p13
Sources: the use and care guides for the Thermador custom insert hoods (p. 17) and the Professional Series hoods (p. 13).
Book a visit. Beeps with no button pressed do not fit the control-tone explanation, which covers only a press asking for something the hood cannot do.
In the Home Connect app. Both guides say the tone can also be switched there, as well as with the 3-second hold of FILTER and LIGHTS.
No. Two short beeps are a control tone answering a button press the hood cannot carry out, and neither guide ties them to extraction.
No. The guide lists duct trouble as a separate symptom on the same page, while two short beeps only answer a button press the hood cannot carry out.
Neither guide says so. Both describe the beeps as the hood answering a button press it cannot carry out. Service is worth booking only if the hood misbehaves in other ways, such as a blower that does not run.
Thermador messages, symptoms, parts, repair visits
Thermador’s hood guides blame weak venting on the installation more often than on the hood: it may sit too high or off-center, make-up air may be short, wind may be pushing in through an open window, or the duct may be blocked, too long or full of elbows. Close windows, clear the duct opening, then book a visit.
Book a diagnostic made for your exact model and performed at the appliance itself.
Where the offices are, and what to tell us about getting in.