Start from the symptom
Thermador hood noisy.
Some noise from a Thermador hood is normal, from vibration and moving air. Excessive noise points to the installation: ductwork that is undersized, oversized or loose, a loose transition, or screws not fully tight. Tighten what you can reach, and call us if the noise stays.

Start with safe observations.
Turn the appliance off and pull the plug before doing any check yourself. Look out for standing water and sharp edges. Never handle a wet plug, remove a service panel or step beyond what your model's guide permits an owner.
- 1
Decide what is normal
The guide says some sound comes from vibration and air movement. A hum at speed is not by itself a problem.
- 2
Tighten screws
The guide lists wood screws not fully tightened and loose screws in trim parts. Go over the visible ones.
- 3
Ductwork size
Ductwork that is too small or too large, or a transition that is loose or undersized, makes noise. Compare it with the installation guide.
- 4
Loose duct
Ductwork that is loose rattles. Securing it is an installer job.
- 5
Noise when off
A sound while the hood is off is usually the flap in the outside wall cap shifting in the wind. The guide calls it normal.
Systems a technician may investigate.
These parts relate to the symptom, though what you noticed cannot show that any single one has failed.
If the display adds a code.
No message is tied directly to this topic.
No other researched dishwasher message is tied to this topic. Compare the exact wording with your model's manual and never substitute another message from the library.
See the research statusWhen observation becomes a service request.
Leave internal testing to a technician.
The noise remains after you tightened every visible screw.
The ductwork is loose or you think it is the wrong size.
You hear scraping from the blower.
The hood trips the breaker when it runs.
Arrange a diagnosticSources and model boundaries.
These documents back up the Thermador hood noisy guidance. Choose the manual written for your model.
- Use and Care Guide, Professional Series Hoods PH30HWS PH36HWS PH48HWS and others
- Use and Care Guide, Masterpiece Chimney Wall Hoods
Match your model to the guide it shipped with. See how we research these pages.
Why does my hood make noise when it is switched off?
The flap in the outside duct wall cap moves with the wind. Thermador calls this normal.
What makes a hood excessively loud?
Ductwork that is too small, too large or loose, a loose or small transition, and screws that are not fully tightened.
Can I fix duct noise myself?
You can tighten visible screws. Resizing or securing ductwork is for an installer.
Does a louder hood mean a failing motor?
Not necessarily. The guide connects excess noise to installation issues first, so check those before suspecting the blower.
Thermador messages, symptoms, parts, repair visits
Move from the message to your next step.
Thermador hood not venting properly
Thermador’s hood guides blame weak venting on the installation more often than on the hood: it may sit too high or off-center, make-up air may be short, wind may be pushing in through an open window, or the duct may be blocked, too long or full of elbows. Close windows, clear the duct opening, then book a visit.
Hood blower, Delay and Auto
A Thermador Professional hood uses a separate remote, in-line or integral blower. DELAY keeps it running for 10 minutes after you finish cooking, then it stops. AUTO lets the hood watch the heat from the cooktop and turn the blower on and off, adjusting every 5 minutes. Only Thermador blowers should be used.
Hood repair
Book a diagnostic made for your exact model and performed at the appliance itself.
Find your metro
Where the offices are, and what to tell us about getting in.

