What it means
F5 with a tone and no flashing on a Thermador range means hot cookware near the control panel already made the zone shut off. Remove it, wait a few seconds, then touch any control.
Thermador range F5 and signal tone / Overheating
F5 with a tone and no flashing on a Thermador range means hot cookware near the control panel already made the zone shut off. Remove it, wait a few seconds, then touch any control.
Also appears as F5 and signal tone
F5 with a tone and no flashing on a Thermador range means hot cookware near the control panel already made the zone shut off. Remove it, wait a few seconds, then touch any control.
Remove the cookware from near the control panel.
F5 and the tone return with nothing near the controls.
Your Thermador steps, stored on this device only

Remove the cookware from near the control panel.

The Thermador manual asks for a short pause.

This acknowledges the message.

When the message is gone and the electronics have cooled.
Give us your model number and the checks you already made, then start your request below.
Book a visit
A simplified drawing, since the layout shifts from one model to the next. Tap any outlined part for its photo and the check that goes with it.
Hot cookware near the panel put the electronics at risk, so the zone shut down.
Read the supporting manualRemove the cookware, wait a few seconds, touch a control, then continue.
Read the supporting manualThe flashing one warns while the zone is still on; this one has already shut it off.
Read the supporting manualManufacturer document
Thermador / BSH Home Appliances (thermador.com/us support page)
Undated web page; fetched 12.11.2026 / entry "F5 and a signal tone"
Source: the ranges page of Thermador's oven support section, entry F5 and a signal tone.
No number is printed. Wait a short while after removing the cookware, then touch any control.
Yes, the Thermador manual pairs the tone with F5. The tone sounds with the shutdown that hot cookware near the control panel caused, to protect the electronics.
The Thermador manual reports no damage. F5 here is a protective shutdown, so once the cookware is gone and the electronics have cooled, you can cook again.
Book a visit if F5 and the tone return with nothing near the panel, since cookware is then ruled out as the cause.
Thermador messages, symptoms, parts, repair visits
On a Thermador Pro range, each rangetop burner has its own igniter and should catch within four seconds. If one will not, Thermador’s first suspect is a burner cap sitting out of alignment. Reseat it, dry everything, and check the knob. Several burners dead, or sparking that never stops, needs a technician.
Book a diagnostic made for your exact model and performed at the appliance itself.
Where the offices are, and what to tell us about getting in.