What it means
E7015 on a Thermador range means the electronics overheated and cooking zones were shut down. The ranges page lists it beside F2 (one zone) and beside F4 (all zones). Wait for cooling, then touch any control.
Thermador range E7015 / Overheating
E7015 on a Thermador range means the electronics overheated and cooking zones were shut down. The ranges page lists it beside F2 (one zone) and beside F4 (all zones). Wait for cooling, then touch any control.
Also appears as E7015
E7015 on a Thermador range means the electronics overheated and cooking zones were shut down. The ranges page lists it beside F2 (one zone) and beside F4 (all zones). Wait for cooling, then touch any control.
The ranges page pairs E7015 with F2 when one zone shuts off and with F4 when all do.
E7015 returns after cooling.
Your Thermador steps, stored on this device only

The ranges page pairs E7015 with F2 when one zone shuts off and with F4 when all do.

Wait until the electronics have cooled down sufficiently.

This clears the display once cool.

Continue once the message has disappeared.
Give us your model number and the checks you already made, then start your request below.
Book a visit
A simplified drawing, since the layout shifts from one model to the next. Tap any outlined part for its photo and the check that goes with it.
Once beside F2 and once beside F4, because the code covers both a single-zone and an all-zone shutdown.
Read the supporting manualThe number of zones that went off decides it.
Read the supporting manualIt is a protective shutdown of overheated electronics.
Read the supporting manualManufacturer document
Thermador / BSH Home Appliances (thermador.com/us support page)
Undated web page; fetched 12.11.2026 / entry "F4 or E7015"
Source: the ranges page of Thermador's oven support section, entries F2 or E7015 and F4 or E7015.
Until the electronics are sufficiently cool; no minutes are printed.
The entry names no cookware cause for E7015. It points to overheated electronics.
The entry speaks only of cooking zones, so the oven is not mentioned. Wait for cooling and touch any control.
Book a visit if E7015 returns after the electronics have cooled.
Thermador messages, symptoms, parts, repair visits
F2 on a Thermador range means the electronics overheated and the related cooking zone was shut down. Wait for cooling, then touch any control.
On a Thermador Pro range, each rangetop burner has its own igniter and should catch within four seconds. If one will not, Thermador’s first suspect is a burner cap sitting out of alignment. Reseat it, dry everything, and check the knob. Several burners dead, or sparking that never stops, needs a technician.
Book a diagnostic made for your exact model and performed at the appliance itself.
Where the offices are, and what to tell us about getting in.