What it means
F5 flashing alternately with the power level and a tone on a Thermador range warns that hot cookware is near the control panel. Remove it and you can keep cooking.
Thermador range F5 and power level flashing with signal tone / Overheating
F5 flashing alternately with the power level and a tone on a Thermador range warns that hot cookware is near the control panel. Remove it and you can keep cooking.
Also appears as F5 and power level flashing with signal tone
F5 flashing alternately with the power level and a tone on a Thermador range warns that hot cookware is near the control panel. Remove it and you can keep cooking.
Look for cookware close to the control panel.
F5 returns with nothing near the control panel.
Your Thermador steps, stored on this device only

Look for cookware close to the control panel.

Take it off the area beside the panel.

The alternating message should clear.

If F5 flashes with nothing near the panel, book a visit.
Give us your model number and the checks you already made, then start your request below.
Book a visit
A simplified drawing, since the layout shifts from one model to the next. Tap any outlined part for its photo and the check that goes with it.
Hot cookware near the control panel, with the electronics at risk of overheating.
Read the supporting manualNot at this stage. The other F5 entry, with a steady tone, describes a zone that has already switched off.
Read the supporting manualYes, once the cookware is removed from the panel.
Read the supporting manualManufacturer document
Thermador / BSH Home Appliances (thermador.com/us support page)
Undated web page; fetched 12.11.2026 / entry "F5 and the power level flashes alternately with a signal tone"
Source: the ranges page of Thermador's oven support section, entry F5 and the power level flashes alternately with a signal tone.
Thermador pairs the tone with the flashing F5 and power level as a warning. It signals hot cookware near the control panel.
Not according to the Thermador manual. F5 warns about cookware near the panel, not a defect in the panel.
Hot cookware near the panel; no types are named.
If it keeps happening with nothing near the panel.
Thermador messages, symptoms, parts, repair visits
On a Thermador Pro range, each rangetop burner has its own igniter and should catch within four seconds. If one will not, Thermador’s first suspect is a burner cap sitting out of alignment. Reseat it, dry everything, and check the knob. Several burners dead, or sparking that never stops, needs a technician.
Book a diagnostic made for your exact model and performed at the appliance itself.
Where the offices are, and what to tell us about getting in.