What it means
E6002 means the heat pump is blocked, according to Thermador's page. Switch the breaker off for 30 seconds and on again; if E6002 returns, book a technician.
Thermador dishwasher E6002 / Heat pump and Crystal Dry
E6002 means the heat pump is blocked, according to Thermador's page. Switch the breaker off for 30 seconds and on again; if E6002 returns, book a technician.
Also appears as E6002
E6002 means the heat pump is blocked, according to Thermador's page. Switch the breaker off for 30 seconds and on again; if E6002 returns, book a technician.
Mention whether the dishwasher fills, washes or stops.
E6002 returns after the reset.
Your Thermador steps, stored on this device only

Mention whether the dishwasher fills, washes or stops.

Power off for 30 seconds, then back on.

Check whether E6002 returns.

The Thermador manual prints no owner step for a blocked heat pump.
Give us your model number and the checks you already made, then start your request below.
Book a visit

A simplified drawing, since the layout shifts from one model to the next. Tap any outlined part for its photo and the check that goes with it.

Component reference
The drain pump sends used wash water out of a Thermador dishwasher.
Read the definition
Component reference
A Thermador dishwasher heats its wash water through a heat pump.
Read the definitionThe heat pump, with no detail on where. The Thermador manual adds no owner check besides the reset.
Read the supporting manualE6001 concerns the internal heater; E6002 concerns a blockage.
Read the supporting manualNo. Drain pump messages are E23, E6101 and the checklist codes.
Read the supporting manualManufacturer document
Thermador / BSH Home Appliances (thermador.com/us support page)
Undated web page; fetched 12.11.2026 / entry "E6002"
Source: the Thermador dishwasher error-code page, entry E6002.
The Thermador manual does not say. Limescale is reported as E12 and E2060.
No owner step is printed for the heat pump.
Leave the breaker off for thirty seconds before switching it on again. If E6002 comes back, book a technician.
The code, the model, and what the cycle did.
Thermador messages, symptoms, parts, repair visits
E6001 describes a problem with the heat pump's internal heater, in the same words Thermador uses for E2030. Switch the dishwasher's breaker off for 30 seconds and back on; if it returns, book a technician.
For a Thermador dishwasher that leaves water behind, the error-code page lists the same four steps for E22, E24 and E25: filter, drain pump cover, drain hose and air gap or hose. The DWHD660EFM guide adds two checks for a display reading E:61-03: remove the garbage disposal plug and keep a high loop in the hose.
The drain pump sends used wash water out of a Thermador dishwasher. Thermador's pages tie it to E22, E23, E24, E25, E6101, E6102 and E6103. Owner steps: reseat the cover over the pump, straighten the drain hose and clear the air gap. A code that keeps returning means a visit.
Book a diagnostic made for your exact model and performed at the appliance itself.
Where the offices are, and what to tell us about getting in.