What it means
E6001 describes a problem with the heat pump's internal heater, in the same words Thermador uses for E2030. Switch the dishwasher's breaker off for 30 seconds and back on; if it returns, book a technician.
Thermador dishwasher E6001 / Heat pump and Crystal Dry
E6001 describes a problem with the heat pump's internal heater, in the same words Thermador uses for E2030. Switch the dishwasher's breaker off for 30 seconds and back on; if it returns, book a technician.
Also appears as E6001
E6001 describes a problem with the heat pump's internal heater, in the same words Thermador uses for E2030. Switch the dishwasher's breaker off for 30 seconds and back on; if it returns, book a technician.
Write down whether the wash completed and whether the water felt warm.
E6001 returns after the reset.
Your Thermador steps, stored on this device only

Write down whether the wash completed and whether the water felt warm.

Switch the breaker off for 30 seconds, then on, as the Thermador manual says.

See whether the message stays away.

The heater inside the heat pump is not an owner repair.
Give us your model number and the checks you already made, then start your request below.
Book a visit

A simplified drawing, since the layout shifts from one model to the next. Tap any outlined part for its photo and the check that goes with it.

Component reference
A Thermador dishwasher heats its wash water through a heat pump.
Read the definitionA problem in the internal heater of the heat pump. The Thermador manual names no cause beyond that.
Read the supporting manualThe text is identical. The sources give no reason for two numbers.
Read the supporting manualE6002 says the heat pump is blocked; E6001 says its heater has a problem.
Read the supporting manualManufacturer document
Thermador / BSH Home Appliances (thermador.com/us support page)
Undated web page; fetched 12.11.2026 / entry "E6001"
Source: the Thermador dishwasher error-code page, entry E6001.
It is the only step the Thermador manual prints, and it clears a one-off error.
Limescale has its own messages, E12 and E2060.
Keep the breaker off for thirty seconds, then switch it back on. A technician is the next step if E6001 returns.
The Thermador manual does not say, so stop if cycles fail.
Thermador messages, symptoms, parts, repair visits
E2030 means the heat pump internal heater has a problem. Switch the breaker off for 30 seconds and on; if E2030 returns, book a technician.
For a Thermador dishwasher that leaves water behind, the error-code page lists the same four steps for E22, E24 and E25: filter, drain pump cover, drain hose and air gap or hose. The DWHD660EFM guide adds two checks for a display reading E:61-03: remove the garbage disposal plug and keep a high loop in the hose.
A Thermador dishwasher heats its wash water through a heat pump. The support page names it in E12 and E2060 (limescale), E2030 and E6001 (internal heater) and E6002 (blocked). For limescale it says to run a descaler and use softener salt where the unit has a softener.
Book a diagnostic made for your exact model and performed at the appliance itself.
Where the offices are, and what to tell us about getting in.