What it means
E2030 means the heat pump internal heater has a problem. Switch the breaker off for 30 seconds and on; if E2030 returns, book a technician.
Thermador dishwasher E2030 / Heat pump and Crystal Dry
E2030 means the heat pump internal heater has a problem. Switch the breaker off for 30 seconds and on; if E2030 returns, book a technician.
Also appears as E2030
E2030 means the heat pump internal heater has a problem. Switch the breaker off for 30 seconds and on; if E2030 returns, book a technician.
Mention whether the dishwasher ran but the water stayed cool or the cycle stopped.
E2030 returns after the reset.
Your Thermador steps, stored on this device only

Mention whether the dishwasher ran but the water stayed cool or the cycle stopped.

Switch the dishwasher's breaker off for 30 seconds, then on, as the Thermador manual says.

Check whether the message stays away.

The internal heater of the heat pump is not an owner repair, so a repeat means a technician.
Give us your model number and the checks you already made, then start your request below.
Book a visit

A simplified drawing, since the layout shifts from one model to the next. Tap any outlined part for its photo and the check that goes with it.

Component reference
A Thermador dishwasher heats its wash water through a heat pump.
Read the definitionA problem with the internal heater of the heat pump. Thermador gives it the same wording as E6001.
Read the supporting manualE2060 reports limescale in the heat pump and calls for descaling. E2030 reports the heater and calls for the breaker reset.
Read the supporting manualThe Thermador manual does not say so. Descaling is the remedy printed for the limescale messages only.
Read the supporting manualManufacturer document
Thermador / BSH Home Appliances (thermador.com/us support page)
Undated web page; fetched 12.11.2026 / entry "E2030"
Source: the dishwasher error-code page from Thermador, entry E2030.
No, E2030 is not a limescale message. Thermador lists limescale as E12 and E2060.
The Thermador manual words them identically, in the four-digit style.
Leave the breaker off for 30 seconds, then switch it back on. Book a technician if E2030 returns.
No owner step is printed, so leave the heater to a technician.
Thermador messages, symptoms, parts, repair visits
E6001 describes a problem with the heat pump's internal heater, in the same words Thermador uses for E2030. Switch the dishwasher's breaker off for 30 seconds and back on; if it returns, book a technician.
For a Thermador dishwasher that leaves water behind, the error-code page lists the same four steps for E22, E24 and E25: filter, drain pump cover, drain hose and air gap or hose. The DWHD660EFM guide adds two checks for a display reading E:61-03: remove the garbage disposal plug and keep a high loop in the hose.
A Thermador dishwasher heats its wash water through a heat pump. The support page names it in E12 and E2060 (limescale), E2030 and E6001 (internal heater) and E6002 (blocked). For limescale it says to run a descaler and use softener salt where the unit has a softener.
Book a diagnostic made for your exact model and performed at the appliance itself.
Where the offices are, and what to tell us about getting in.