What it means
U400 means the supply voltage is outside the cooktop's normal range, in the wording E9000 and E9010 share. No owner step is printed; have the supply checked by an electrician.
Thermador cooktop U400 / Power supply
U400 means the supply voltage is outside the cooktop's normal range, in the wording E9000 and E9010 share. No owner step is printed; have the supply checked by an electrician.
Also appears as U400
U400 means the supply voltage is outside the cooktop's normal range, in the wording E9000 and E9010 share. No owner step is printed; have the supply checked by an electrician.
Mains power is involved.
U400 appears again.
Your Thermador steps, stored on this device only

Record the display.

Check for other voltage trouble.

Leave the cooktop wiring alone.

Tell us when it shows.
Give us your model number and the checks you already made, then start your request below.
Book a visit
A simplified drawing, since the layout shifts from one model to the next. Tap any outlined part for its photo and the check that goes with it.
A supply-voltage message in Thermador's list.
Read the supporting manualThe wording is the same.
Read the supporting manualAn electrician or utility.
Read the supporting manualThe Freedom induction guide prints the same supply-voltage row: the voltage is incorrect and outside the normal operating range, and the only step is to contact your electrical utility provider.
Read the supporting manualManufacturer document
Thermador / BSH Home Appliances (thermador.com/us support page)
Undated web page; fetched 12.11.2026 / entry "U400"
Manufacturer document
BSH Home Appliances Corporation (Thermador US manual PDF, media3.bsh-group.com)
PDF created 25.09.2026; file tag _H (no printed edition date read) / PDF p32
Source: the Thermador induction cooktop error-code page, entry U400. The Freedom induction cooktop guide prints the same supply-voltage row.
The Thermador manual points at the supply. U400 says the supply voltage is outside the cooktop's normal range, so have the supply checked by an electrician before blaming the cooktop.
No reset is listed. Note the code and tell us when it shows; the Freedom guide's only step is to contact your electrical utility provider.
The sources do not rate it. Leave the cooktop wiring alone and have the supply checked, since the code points to a voltage outside the normal range.
Book a visit if U400 appears again after the supply has been checked. Tell us when it shows and what else in the kitchen behaved oddly.
The Freedom guide says the cooktop may temporarily lower its power level to protect its electronics from overheating or surge currents. It does not tie that to U400 or give a voltage figure, so note when the message appears and how the rest of the kitchen behaves.
Thermador messages, symptoms, parts, repair visits
When one Thermador burner will not light while the rest do, the support page points to the burner cap: it is out of alignment, and its tabs must sit in the notches on the burner base. The cooktop guide adds a 4-second rule and clean, dry igniter ports. Gas odor means shut the unit off and book a visit.
Book a diagnostic made for your exact model and performed at the appliance itself.
Where the offices are, and what to tell us about getting in.