What it means
E9000 means the supply voltage reaching a Thermador cooktop is outside its normal range. The Thermador manual names no owner step; have the supply checked by an electrician and book a visit.
Thermador cooktop E9000 / Power supply
E9000 means the supply voltage reaching a Thermador cooktop is outside its normal range. The Thermador manual names no owner step; have the supply checked by an electrician and book a visit.
Also appears as E9000
E9000 means the supply voltage reaching a Thermador cooktop is outside its normal range. The Thermador manual names no owner step; have the supply checked by an electrician and book a visit.
Mains power is involved.
The code appears on more than one use.
Your Thermador steps, stored on this device only

Write down the code and whether it appears at the same time of day.

Flickering lights or tripping breakers suggest a supply problem in the house.

Wiring is not an owner job.

We can check what voltage the cooktop sees.
Give us your model number and the checks you already made, then start your request below.
Book a visit
A simplified drawing, since the layout shifts from one model to the next. Tap any outlined part for its photo and the check that goes with it.
The cooktop is receiving too much or too little voltage. The Thermador manual points to the electrical utility rather than a part.
Read the supporting manualE9011 says the appliance is not connected correctly; E9000 says the voltage is out of range.
Read the supporting manualThermador prints them as one entry, so their meaning matches.
Read the supporting manualManufacturer document
Thermador / BSH Home Appliances (thermador.com/us support page)
Undated web page; fetched 12.11.2026 / entry "E9000 or E9010"
Source: the Thermador induction cooktop error-code page, entry E9000 or E9010.
The Thermador manual suggests contacting the utility, which means the supply may be the issue.
The source does not say. Do not keep trying.
A supply check by a qualified person is sensible.
U400 and E9010 use similar wording for the supply voltage. All three point to the power reaching the cooktop.
Thermador messages, symptoms, parts, repair visits
E9010 uses the same wording as E9000: the supply voltage is out of the cooktop's normal range. Have the supply checked and book a visit; the Thermador manual has no owner step.
When one Thermador burner will not light while the rest do, the support page points to the burner cap: it is out of alignment, and its tabs must sit in the notches on the burner base. The cooktop guide adds a 4-second rule and clean, dry igniter ports. Gas odor means shut the unit off and book a visit.
Book a diagnostic made for your exact model and performed at the appliance itself.
Where the offices are, and what to tell us about getting in.