What it means
E9010 uses the same wording as E9000: the supply voltage is out of the cooktop's normal range. Have the supply checked and book a visit; the Thermador manual has no owner step.
Thermador cooktop E9010 / Power supply
E9010 uses the same wording as E9000: the supply voltage is out of the cooktop's normal range. Have the supply checked and book a visit; the Thermador manual has no owner step.
Also appears as E9010
E9010 uses the same wording as E9000: the supply voltage is out of the cooktop's normal range. Have the supply checked and book a visit; the Thermador manual has no owner step.
Mains power is involved.
The code appears on more than one use.
Your Thermador steps, stored on this device only

Thermador prints E9000 and E9010 together, so either may be shown.

Check whether other appliances misbehave at the same time.

No cover removal or wiring work.

Tell us when it appears.
Give us your model number and the checks you already made, then start your request below.
Book a visit
A simplified drawing, since the layout shifts from one model to the next. Tap any outlined part for its photo and the check that goes with it.
The Thermador manual lists it with E9000 under one entry.
Read the supporting manualLittle beyond the breaker and symptoms elsewhere; the supply itself is for an electrician.
Read the supporting manualThe note on our pages treats U400 as another supply-voltage message.
Read the supporting manualManufacturer document
Thermador / BSH Home Appliances (thermador.com/us support page)
Undated web page; fetched 12.11.2026 / entry "E9000 or E9010"
Source: the Thermador induction cooktop error-code page, entry E9000 or E9010.
Either; the Thermador manual says outside the normal operating range.
Thermador does not rate E9010 as dangerous. It is wise to avoid using the cooktop repeatedly until the supply is checked.
Thermador does not suggest a breaker reset for E9010. Have the supply checked instead.
The utility or an electrician looks after the supply. The cooktop itself is not the first thing to check.
Thermador messages, symptoms, parts, repair visits
E9000 means the supply voltage reaching a Thermador cooktop is outside its normal range. The Thermador manual names no owner step; have the supply checked by an electrician and book a visit.
When one Thermador burner will not light while the rest do, the support page points to the burner cap: it is out of alignment, and its tabs must sit in the notches on the burner base. The cooktop guide adds a 4-second rule and clean, dry igniter ports. Gas odor means shut the unit off and book a visit.
Book a diagnostic made for your exact model and performed at the appliance itself.
Where the offices are, and what to tell us about getting in.