What it means
F5 shown with the heat level and a tone on a Thermador electric cooktop is a warning: hot cookware near the controls puts the electronics at risk. Move the cookware away from the control panel.
Thermador cooktop F5 with heat level and signal tone / Overheating
F5 shown with the heat level and a tone on a Thermador electric cooktop is a warning: hot cookware near the controls puts the electronics at risk. Move the cookware away from the control panel.
Also appears as F5 with heat level and signal tone
F5 shown with the heat level and a tone on a Thermador electric cooktop is a warning: hot cookware near the controls puts the electronics at risk. Move the cookware away from the control panel.
Look for hot cookware close to the panel.
F5 returns with nothing near the controls.
Your Thermador steps, stored on this device only

Look for hot cookware close to the panel.

Remove the cookware from the control panel area.

The warning stage does not stop the zone.

If F5 returns with nothing near the controls, book a visit.
Give us your model number and the checks you already made, then start your request below.
Book a visit
A simplified drawing, since the layout shifts from one model to the next. Tap any outlined part for its photo and the check that goes with it.

Component reference
The control panel on a Thermador Freedom induction cooktop has touch keys and a touchscreen.
Read the definition
Component reference
The electronics of a Thermador cooktop or range cooktop run the zones and protect themselves from overheating.
Read the definitionHot cookware near the control panel means the electronics could overheat.
Read the supporting manualThis warning leaves the zone on; the other entry says the zone has already switched off.
Read the supporting manualYes, this wording is from the electric page.
Read the supporting manualManufacturer document
Thermador / BSH Home Appliances (thermador.com/us support page)
Undated web page; fetched 12.11.2026 / entry "F5 with heat level and signal tone"
Source: the error-code page for Thermador electric cooktops, entry F5 with heat level and signal tone.
Move the hot pan or pot away from the control panel. That is the cookware Thermador's warning refers to.
Thermador's warning gives no waiting time. Simply move the hot cookware away from the panel.
The entry words it as F5 with the heat level.
Book a visit if F5 and the tone continue with nothing hot near the panel. The sources give no other owner step.
Thermador messages, symptoms, parts, repair visits
F5 with a tone and no flashing means hot cookware near the control panel already made the cooking zone switch off to protect the electronics. Remove the cookware, wait a few seconds, then touch any control.
When one Thermador burner will not light while the rest do, the support page points to the burner cap: it is out of alignment, and its tabs must sit in the notches on the burner base. The cooktop guide adds a 4-second rule and clean, dry igniter ports. Gas odor means shut the unit off and book a visit.
The electronics of a Thermador cooktop or range cooktop run the zones and protect themselves from overheating. F2 means the electronics overheated and one zone shut off; F4 shuts all zones; E7015, E8207 and E8208 are listed with them. Wait for the electronics to cool, then touch any control.
Book a diagnostic made for your exact model and performed at the appliance itself.
Where the offices are, and what to tell us about getting in.