What it means
dE on a Thermador cooktop means demo mode is on, so the cooking zones stay cold. Switch the breaker or fuse off for 30 seconds, restore it, and touch any control within 3 minutes.
Thermador cooktop dE / Modes and limits
dE on a Thermador cooktop means demo mode is on, so the cooking zones stay cold. Switch the breaker or fuse off for 30 seconds, restore it, and touch any control within 3 minutes.
Also appears as dE
dE on a Thermador cooktop means demo mode is on, so the cooking zones stay cold. Switch the breaker or fuse off for 30 seconds, restore it, and touch any control within 3 minutes.
In the electrical panel, find the breaker or fuse that feeds the cooktop.
dE returns after the reset.
Your Thermador steps, stored on this device only

In the electrical panel, find the breaker or fuse that feeds the cooktop.

Switch it off for half a minute, then back on.

You have 3 minutes after power returns to touch any control on the cooktop.

If the zones now heat, demo mode is off.
Give us your model number and the checks you already made, then start your request below.
Book a visit
A simplified drawing, since the layout shifts from one model to the next. Tap any outlined part for its photo and the check that goes with it.
Demo mode keeps the zones cold, which is why Thermador files it under "cooking zones do not heat up".
Read the supporting manualNo. It is a mode that has been switched on, and the power reset in the Thermador manual turns it off.
Read the supporting manualThe 3-minute window after restoring power is when a control touch confirms the change. Miss it and the sequence needs repeating.
Read the supporting manualManufacturer document
Thermador / BSH Home Appliances (thermador.com/us support page)
Undated web page; fetched 12.11.2026 / entry "dE and cooking zones do not heat up"
Manufacturer document
Thermador / BSH Home Appliances (thermador.com/us support page)
Undated web page; fetched 12.11.2026 / entry "dE and cooking zones do not heat up"
Sources: the induction cooktop and electric cooktop error-code pages from Thermador, which carry the same wording.
Yes. Thermador lists the same entry on both support pages.
The reset is done at the panel by switching a breaker, which most owners can do. Do not open the cooktop.
Repeat the breaker reset once, and book a visit if dE shows up again. The first try is the only owner step Thermador gives.
Lowercase d, capital E, as the display prints it.
Thermador messages, symptoms, parts, repair visits
When one Thermador burner will not light while the rest do, the support page points to the burner cap: it is out of alignment, and its tabs must sit in the notches on the burner base. The cooktop guide adds a 4-second rule and clean, dry igniter ports. Gas odor means shut the unit off and book a visit.
Book a diagnostic made for your exact model and performed at the appliance itself.
Where the offices are, and what to tell us about getting in.