On this page
- Cycling and a periodic igniter click are normal on XLO, and nothing to clean or touch while it runs. 13
- Five XLO settings on the Masterpiece gas cooktop; two on rangetops and ranges. 134
- A rangetop's lowest XLO runs about 10 seconds on and 50 off in each minute; the highest runs about 50 on, 10 off. 4
- No manual lighting of an ExtraLow burner in a power failure. 4
Why does the ExtraLow flame turn itself off and back on?#
Because that is how it holds a very low heat. Thermador's pages say that when the knob is set within an XLO setting, the flame cycles on and off automatically, and that this cycling is normal. 12
The cycle lets the burner go lower than a conventional Low setting, so you can simmer, poach, melt or keep cooked food warm without scorching it. 13 On the Professional rangetop the manual puts numbers on it: the flame runs through a 60-second cycle, as low as about 10 seconds on and 50 seconds off, and the burner's XLO simmer also shows a slightly higher flame than the simmer on a standard Star burner. Both things are called normal there. 4
How many XLO settings does my Thermador have?#
A Masterpiece SGSX or SGSXP gas cooktop has five XLO settings on two burners, the center and the left front. Thermador's range and rangetop pages describe two settings, a low one and a higher one. 1234
On the five-level cooktop, XLO 5 has the highest heating level and keeps the flame on the longest; XLO 1 is the lowest. A slight catch under the knob marks the LO position and each XLO setting. 3 The SG and SGSP cooktops in the same manual have no ExtraLow feature at all, only standard knobs, so no XLO marking appears on them. 3 If your knob shows no XLO range, you do not have the feature.
How do I use an ExtraLow burner step by step?#
Set the pan on the burner, press the knob down and rotate it counterclockwise into the XLO range, then check the food from time to time. Stir when simmering for hours. 13
- 1
- 2
- 3
- 4
- 5
What should I cook on a low XLO and what on a high one?#
The lowest setting suits delicate sauces such as béchamel, cream sauces and marinara, and melting butter, chocolate or polenta. The higher setting keeps hot food hot, for stir fry, poached eggs or scrambled eggs. 12
On the five-level cooktop Thermador groups them: levels 1 and 2 for the delicate sauces and melting, level 3 for very light braising, levels 4 and 5 for holding hot food. 1 The Professional rangetop manual gives two worked examples: melting chocolate on XLO takes 10 to 15 minutes and may be stirred, and tomato sauce can finish on XLO uncovered to thicken, where a standard burner would use LO to hold a simmer. 4 The cooktop manual adds that the amount and kind of food affect the choice, and says to try the lower value first because heat can be raised during cooking. 3
What if it will not hold a simmer?#
Bring the food back to a boil and then set a higher heat. Thermador's tip says a setting that is too low cannot hold a simmer, so do not keep waiting on it. 13
A few related tips from the same pages help. Use a lower XLO setting when the pan has a lid. In an oversized pan the simmering concentrates in the center, so stir the outer edges into the middle. And lower the setting one XLO step at a time, not in a jump. 13
Why does the igniter click while the pot sits on XLO?#
Each time the flame cycles back on, the burner's electronic igniter sparks to relight it. On the Masterpiece cooktop the manual says a slight clicking noise comes about every 60 seconds. 3
Do not touch or clean a burner while an ExtraLow burner is running, because it can spark at any moment. 3 The rangetop manual also says that if a burner blows out, the electronic igniter relights the flame automatically and you should not touch the burners while igniters are active. 4 If the clicking is continuous with a steady flame and no XLO setting in use, that is a different situation; see our page for the igniter that keeps clicking.
Do I need to do anything to the burner afterward?#
Clean the grates, caps and bases the way the manual describes once the surface is cold, and check that each cap sits flat on its base. A cap that is not seated is the first item the manual says to check if a burner stays dark. 4
The manual's cap test: there should be no gap between cap and base, and gently moving the cap side to side should produce a click as the prongs meet the ridge. 3 For the cleaning itself, see our guide to grates, caps, griddle and briquettes.
What signals a real burner problem?#
A burner that stays dark with a seated cap, an XLO knob position where the flame never cycles, igniter clicking with a steady flame, or a flame that looks wrong. A gas smell means leave first and phone from outside. 34
For those, reserve a visit with our technicians, who test ignition on site. A cooktop within Thermador's own warranty term is repaired by Thermador. We confirm the price with you in advance; the final figure follows the diagnosis. The cooktop service page outlines a gas visit.
Sources#
- How to Use Extra Low Burners | Gas Cooktops Support | ThermadorThermador (thermador.com, US support site) · Page undated; retrieved 12.11.2026 · Page text: steps, five-level and two-level descriptions, tips
- Extra Low Burners | Ranges Support | ThermadorThermador (thermador.com, US support site) · Page undated; retrieved 12.11.2026 · Page text for rangetops and ranges
- Use and Care GUIDE: SGS SGSX SGSP SGSXP Masterpiece Series Gas CooktopThermador (BSH Home Appliances), mixed print edition · File tag 8001139789_A · PDF pages 12-13 (XLO burners and knobs), 18-19 (cooking with XLO)
- Use and care GUIDE: Professional Series Rangetops PCG305W PCG366W PCG364WD PCG486WDThermador (BSH Home Appliances), en-us edition · File tag 8001265284_A · PDF pages 10-11 (rangetop operation, ExtraLow feature, recommended settings)





