What it means
U400 on a Thermador range means the supply voltage is outside the normal operating range, in the wording E9000 and E9010 share. No owner step is printed; have an electrician check the supply.
Thermador range U400 / Power supply
U400 on a Thermador range means the supply voltage is outside the normal operating range, in the wording E9000 and E9010 share. No owner step is printed; have an electrician check the supply.
Also appears as U400
U400 on a Thermador range means the supply voltage is outside the normal operating range, in the wording E9000 and E9010 share. No owner step is printed; have an electrician check the supply.
Mains power is involved.
U400 appears again.
Your Thermador steps, stored on this device only

Write down U400 and when it appeared.

Lights that flicker or breakers that trip suggest a supply problem in the house.

Wiring and terminals are not an owner job.

We can check the voltage reaching the range.
Give us your model number and the checks you already made, then start your request below.
Book a visitA simplified drawing, since the layout shifts from one model to the next. Tap any outlined part for its photo and the check that goes with it.
An incorrect supply voltage, outside the normal operating range. The ranges page tells you to contact the utility.
Read the supporting manualThe wording is the same. They differ only in the number shown.
Read the supporting manualNote the symptoms and have the supply tested; nothing inside the range is an owner task.
Read the supporting manualManufacturer document
Thermador / BSH Home Appliances (thermador.com/us support page)
Undated web page; fetched 12.11.2026 / entry "U400"
Source: the ranges page of Thermador's oven support section, entry U400.
The Thermador manual points at the supply, not at the range. U400 reports a supply voltage outside the normal operating range, and the ranges page tells you to contact the utility.
None is listed for U400. Record the display and when it appeared, then have an electrician check the supply.
The Thermador manual does not rate it, so avoid repeated attempts. Leave the range closed and have the supply checked, since wiring and terminals are not an owner job.
Book a visit if U400 appears again after the supply has been checked. We can measure the voltage reaching the range.
Thermador messages, symptoms, parts, repair visits
On a Thermador Pro range, each rangetop burner has its own igniter and should catch within four seconds. If one will not, Thermador’s first suspect is a burner cap sitting out of alignment. Reseat it, dry everything, and check the knob. Several burners dead, or sparking that never stops, needs a technician.
Book a diagnostic made for your exact model and performed at the appliance itself.
Where the offices are, and what to tell us about getting in.