What it means
E9000 on a Thermador range means the supply voltage is outside the normal range. The Thermador manual has no owner step; have the supply checked by an electrician.
Thermador range E9000 / Power supply
E9000 on a Thermador range means the supply voltage is outside the normal range. The Thermador manual has no owner step; have the supply checked by an electrician.
Also appears as E9000
E9000 on a Thermador range means the supply voltage is outside the normal range. The Thermador manual has no owner step; have the supply checked by an electrician.
Mains power is involved.
The code appears on more than one use.
Your Thermador steps, stored on this device only

Write down E9000 and the time it appeared.

Flickering lights or other appliances acting up suggest a supply problem.

Wiring and terminals are not an owner job.

We can check what voltage reaches the range.
Give us your model number and the checks you already made, then start your request below.
Book a visitA simplified drawing, since the layout shifts from one model to the next. Tap any outlined part for its photo and the check that goes with it.
The supply voltage reaching it is outside the normal operating range.
Read the supporting manualThermador prints E9000 and E9010 as one entry, so the meaning is shared.
Read the supporting manualAn electrician or the utility; the Thermador manual names no owner step.
Read the supporting manualManufacturer document
Thermador / BSH Home Appliances (thermador.com/us support page)
Undated web page; fetched 12.11.2026 / entry "E9000 or E9010"
Source: the ranges page of Thermador's oven support section, entry E9000 or E9010.
The Thermador manual says only that it is outside the normal range.
No, Thermador lists no reset for E9000. Have an electrician check the supply instead.
The Thermador manual does not rate it, so avoid repeated attempts.
If the code shows on more than one use.
Thermador messages, symptoms, parts, repair visits
E9010 on a Thermador range has the same wording as E9000: the supply voltage is outside the normal range. Have the supply checked and book a visit.
On a Thermador Pro range, each rangetop burner has its own igniter and should catch within four seconds. If one will not, Thermador’s first suspect is a burner cap sitting out of alignment. Reseat it, dry everything, and check the knob. Several burners dead, or sparking that never stops, needs a technician.
Book a diagnostic made for your exact model and performed at the appliance itself.
Where the offices are, and what to tell us about getting in.