What it means
F6 on a Thermador range shares the F1 entry: a cooking zone overheated and shut off to protect the work surface. Wait for cooling, then switch the zone back on.
Thermador range F6 / Overheating
F6 on a Thermador range shares the F1 entry: a cooking zone overheated and shut off to protect the work surface. Wait for cooling, then switch the zone back on.
Also appears as F6
F6 on a Thermador range shares the F1 entry: a cooking zone overheated and shut off to protect the work surface. Wait for cooling, then switch the zone back on.
Take the cookware off the zone.
F6 returns after cooling.
Your Thermador steps, stored on this device only

Take the cookware off the zone.

Let them cool sufficiently.

Then carry on cooking.

If F6 returns, record the zone.
Give us your model number and the checks you already made, then start your request below.
Book a visit
A simplified drawing, since the layout shifts from one model to the next. Tap any outlined part for its photo and the check that goes with it.
No. The ranges page prints F1 or F6 as one entry.
Read the supporting manualThe work surface.
Read the supporting manualThe entry does not mention it.
Read the supporting manualThe cooktop table has separate rows for a zone overheating to protect the work surface, electronics overheating so that one zone or all zones switch off, hot cookware near the control panel, and the time limit. F6 belongs to the work-surface row.
Read the supporting manualManufacturer document
Thermador / BSH Home Appliances (thermador.com/us support page)
Undated web page; fetched 12.11.2026 / entry "F1 or F6"
Manufacturer document
BSH Home Appliances Corporation (Thermador US manual PDF, media3.bsh-group.com)
PDF created 24.04.2023; file tag _D (no printed edition date read) / PDF p53
Source: the ranges page of Thermador's oven support section, entry F1 or F6. The Pro Harmony induction range guide prints the matching troubleshooting row.
A cooking zone overheated and shut off to protect the work surface. That is the cause Thermador gives for F6.
No, F6 is not about the electronics. Thermador covers overheated electronics under F2 and F4 instead.
After cooling and switching the zone back on.
Book a visit if F6 repeats on a cool surface.
Thermador messages, symptoms, parts, repair visits
F1 on a Thermador range means a cooking zone overheated and shut off to protect the work surface. Wait for the electronics to cool, then switch the zone back on.
On a Thermador Pro range, each rangetop burner has its own igniter and should catch within four seconds. If one will not, Thermador’s first suspect is a burner cap sitting out of alignment. Reseat it, dry everything, and check the knob. Several burners dead, or sparking that never stops, needs a technician.
Book a diagnostic made for your exact model and performed at the appliance itself.
Where the offices are, and what to tell us about getting in.