What it means
E0510 on a Thermador range is listed with E0211 and E1601 as a Home Connect software update code. The Thermador manual points to a resolution link.
Thermador range E0510 / Home Connect messages
E0510 on a Thermador range is listed with E0211 and E1601 as a Home Connect software update code. The Thermador manual points to a resolution link.
Also appears as E0510
E0510 on a Thermador range is listed with E0211 and E1601 as a Home Connect software update code. The Thermador manual points to a resolution link.
E0510 appears during a Home Connect software update, so let that run first.
The code stays after the update finishes.
Your Thermador steps, stored on this device only

E0510 appears during a Home Connect software update, so let that run first.

Check whether Home Connect shows the update as complete.

The ranges page has a click-here resolution link for the three update codes.

If E0510 remains afterward, book a visit.
Give us your model number and the checks you already made, then start your request below.
Book a visitA simplified drawing, since the layout shifts from one model to the next. Tap any outlined part for its photo and the check that goes with it.
A Home Connect update error code, grouped on the ranges page with E0211 and E1601.
Read the supporting manualNo. The coffee machine page words E0510 as a general error and says to follow the screen.
Read the supporting manualThe Thermador manual does not separate them, so we cannot name a difference.
Read the supporting manualManufacturer document
Thermador / BSH Home Appliances (thermador.com/us support page)
Undated web page; fetched 12.11.2026 / entry "E0211, E1601, E0510 appear during a Home Connect software update"
Source: the ranges page of Thermador's oven support section, entry for E0211, E1601 and E0510.
No, Thermador calls E0510 a Home Connect software update code, not a broken part. It sits with E0211 and E1601.
Home Connect runs the update, so the range needs its network connection.
Behind the Thermador manual's resolution link; the manual prints no other steps.
Book a visit if E0510 persists after the software update has been done.
Thermador messages, symptoms, parts, repair visits
An E with digits and a beep on a Thermador range is an error code the Thermador manual does not decode. Press TIMERS or any key to stop the beep, reset if necessary, and book a visit if it returns.
On a Thermador Pro range, each rangetop burner has its own igniter and should catch within four seconds. If one will not, Thermador’s first suspect is a burner cap sitting out of alignment. Reseat it, dry everything, and check the knob. Several burners dead, or sparking that never stops, needs a technician.
Book a diagnostic made for your exact model and performed at the appliance itself.
Where the offices are, and what to tell us about getting in.