What it means
An E with digits and a beep on a Thermador range is an error code the Thermador manual does not decode. Press TIMERS or any key to stop the beep, reset if necessary, and book a visit if it returns.
Thermador range E and a number with beep / Electronics
An E with digits and a beep on a Thermador range is an error code the Thermador manual does not decode. Press TIMERS or any key to stop the beep, reset if necessary, and book a visit if it returns.
Also appears as E and a number with beep
An E with digits and a beep on a Thermador range is an error code the Thermador manual does not decode. Press TIMERS or any key to stop the beep, reset if necessary, and book a visit if it returns.
Press TIMERS or any other key.
The E number comes back after the reset.
Your Thermador steps, stored on this device only

Press TIMERS or any other key.

Copy the E number exactly.

Do this if necessary.
If the number keeps showing, turn the oven off and book.
Give us your model number and the checks you already made, then start your request below.
Book a visitA simplified drawing, since the layout shifts from one model to the next. Tap any outlined part for its photo and the check that goes with it.
Only E0211, E1601 and E0510, as Home Connect update codes.
Read the supporting manualThey have separate entries, such as E7010, the F-codes and the supply messages.
Read the supporting manualThe exact digits and whether the cooktop or the oven was in use.
Read the supporting manualManufacturer document
Thermador / BSH Home Appliances (thermador.com/us support page)
Undated web page; fetched 12.11.2026 / entry ""E" and a number appears on the display and the control beeps"
Source: the ranges page of Thermador's oven support section, entry for an E number with a beep.
Thermador does not rank the beep as dangerous. It only says to stop the beeping and reset if necessary.
The Thermador manual says to reset if necessary and call if the code continues.
The wording comes from the oven section of the Thermador manual.
Book a visit if the code continues to show up after you have reset the range.
Thermador messages, symptoms, parts, repair visits
E0211 on a Thermador range appears during a Home Connect software update. The ranges page offers a resolution link and no steps of its own.
On a Thermador Pro range, each rangetop burner has its own igniter and should catch within four seconds. If one will not, Thermador’s first suspect is a burner cap sitting out of alignment. Reseat it, dry everything, and check the knob. Several burners dead, or sparking that never stops, needs a technician.
Book a diagnostic made for your exact model and performed at the appliance itself.
Where the offices are, and what to tell us about getting in.