Thermador dishwasher E6160 / Heat pump and Crystal Dry
Thermador dishwasher code E6160
Dishwasher / display reference
E6160 is read two ways. The support page says the Zone Control lower spray arm reference position was not found; the DWHD660EFM guide calls E:61-60 a technical error and sends you to service. Restart, then check the spray arm turns freely.
E6160 is read two ways. The support page says the Zone Control lower spray arm reference position was not found; the DWHD660EFM guide calls E:61-60 a technical error and sends you to service. Restart, then check the spray arm turns freely.
E6160 is read two ways. The support page says the Zone Control lower spray arm reference position was not found; the DWHD660EFM guide calls E:61-60 a technical error and sends you to service. Restart, then check the spray arm turns freely.
What you can safely check
Lift it by hand and see whether it spins without catching.
When to call a technician
E6160 returns after a restart.
Your Thermador steps, stored on this device only
Safe checks, in order.
0 of 4 checks done
Illustration. Follow your model’s instructions.
Before you begin
Check the lower spray arm
Lift it by hand and see whether it spins without catching.
Illustration. Follow your model’s instructions.
Check 2
Restart the dishwasher
Switch it off and on, then run a short cycle.
Illustration. Follow your model’s instructions.
Check 3
Note the readings
Report that the Thermador manual and the guide read the code differently.
Illustration. Follow your model’s instructions.
Check 4
Book a visit
Neither source prints an owner repair.
Is E6160 still on the display?
Give us your model number and the checks you already made, then start your request below.