What it means
E2120 means the heater in the Zeolite (Crystal Dry) chamber has a problem. Switch the breaker off for 30 seconds and back on; if it persists, book a technician.
Thermador dishwasher E2120 / Heat pump and Crystal Dry
E2120 means the heater in the Zeolite (Crystal Dry) chamber has a problem. Switch the breaker off for 30 seconds and back on; if it persists, book a technician.
Also appears as E2120
E2120 means the heater in the Zeolite (Crystal Dry) chamber has a problem. Switch the breaker off for 30 seconds and back on; if it persists, book a technician.
Notice whether dishes come out wetter than usual, since Crystal Dry is the drying system.
E2120 returns after the reset.
Your Thermador steps, stored on this device only

Notice whether dishes come out wetter than usual, since Crystal Dry is the drying system.

Switch the breaker off for 30 seconds and back on.

See whether the message returns.

The chamber heater is a technician job.
Give us your model number and the checks you already made, then start your request below.
Book a visit

A simplified drawing, since the layout shifts from one model to the next. Tap any outlined part for its photo and the check that goes with it.

Component reference
Zeolite is a mineral in a Thermador dishwasher's drying system that holds moisture, then gives heat back.
Read the definitionThe Crystal Dry drying chamber; the Thermador manual names a heater problem inside it.
Read the supporting manualE2120 is the chamber heater, E2130 the fan motor of the same system.
Read the supporting manualResetting power at the breaker for 30 seconds.
Read the supporting manualManufacturer document
Thermador / BSH Home Appliances (thermador.com/us support page)
Undated web page; fetched 12.11.2026 / entry "E2120"
Source: the dishwasher error-code page from Thermador, entry E2120.
No, it concerns drying. E2120 names the heater in the Zeolite (Crystal Dry) chamber, so notice whether dishes come out wetter than usual.
Yes, it sits in the same Crystal Dry system. E2130 names the fan motor of that system, while E2120 names the chamber heater.
Switch the breaker off for 30 seconds and back on. That is the only owner step the Thermador manual gives for E2120.
The code, the model and how dry the dishes were. Book a visit if E2120 returns after the 30-second breaker reset.
Thermador messages, symptoms, parts, repair visits
E2130 is read two ways. Thermador's support page says the Zeolite (Crystal Dry) fan motor is defective and gives a breaker reset; the DWHD660EFM guide says dishware is covering the Zeolite intake opening. Clear the intake, then reset the breaker.
For a Thermador dishwasher that leaves water behind, the error-code page lists the same four steps for E22, E24 and E25: filter, drain pump cover, drain hose and air gap or hose. The DWHD660EFM guide adds two checks for a display reading E:61-03: remove the garbage disposal plug and keep a high loop in the hose.
Zeolite is a mineral in a Thermador dishwasher's drying system that holds moisture, then gives heat back. Thermador's page ties E2120 to the chamber heater and E2130 to the fan motor. The DWHD660EFM guide reads E:21-30 as dishes covering the intake.
Book a diagnostic made for your exact model and performed at the appliance itself.
Where the offices are, and what to tell us about getting in.