Inside the appliance
Hood LED lights and heat lamps. In plain English.
A Thermador Professional hood has LED lights that you press LIGHTS to switch on, dim and turn off in three presses. PHxxGWS models also carry infrared heat lamps. To change a heat lamp, turn the hood off, let the lamp cool, unscrew it counterclockwise and fit a PAR-38 175W or PAR-40 250W lamp.

Where it fits.
Hood LED lights and heat lamps in the appliance
Under the hood canopy; heat lamps screw into sockets on PHxxGWS models.
The picture stands for a type of component. Which replacement suits your model is a separate question.
What shifts when this system needs a look.
Hood LED lights and heat lamps concerns may show up next to a drop in performance or a message that keeps returning. Testing comes before any verdict on the component.

Thermador hood not venting properly
Thermador’s hood guides blame weak venting on the installation more often than on the hood: it may sit too high or off-center, make-up air may be short, wind may be pushing in through an open window, or the duct may be blocked, too long or full of elbows. Close windows, clear the duct opening, then book a visit.

Thermador hood noisy
Some noise from a Thermador hood is normal, from vibration and moving air. Excessive noise points to the installation: ductwork that is undersized, oversized or loose, a loose transition, or screws not fully tight. Tighten what you can reach, and call us if the noise stays.
Owner care, within the model instructions.
Turn the appliance off and pull the plug before doing any check yourself. Look out for standing water and sharp edges. Never handle a wet plug, remove a service panel or step beyond what your model's guide permits an owner.
- 1
Press LIGHTS three times
One press turns the lights on, the second dims them and the third turns them off.
- 2
Rule out the breaker
The troubleshooting table lists a tripped breaker when the lights and the blower both stay dead.
- 3
Let heat lamps cool
Turn off the lamps and blower, wait until the lamps are cool, then turn the lamp counterclockwise out of its socket.
- 4
Seat a new lamp fully
If a new heat lamp does not work, check that it is inserted correctly before you book.
Cleaning or replacement?
Leave internal testing to a technician.
Lights and blower are both dead although the breaker is on.
A new heat lamp does not light after you have reseated it.
Arrange a diagnosticSources and model boundaries.
These documents back up the Hood LED lights and heat lamps guidance. Choose the manual written for your model.
- Use and Care Guide, Professional Series Hoods PH30HWS PH36HWS PH48HWS and others
Match your model to the guide it shipped with. See how we research these pages.
How do I dim the hood lights?
Press LIGHTS twice. The first press turns them on, the second dims them and the third turns them off.
Can I set a light level in the app?
The guide says the Home Connect app has a 0 to 100 percent light slider.
Which heat lamp fits?
The guide lists a PAR-38 175W lamp, or a PAR-40 250W lamp as a more widely sold alternative.
Can I run the hood without the heat lamps?
Never run a PHxxGWS hood with its heat lamps missing; the guide is clear on that.
Thermador messages, symptoms, parts, repair visits
Move from the message to your next step.
Thermador hood not venting properly
Thermador’s hood guides blame weak venting on the installation more often than on the hood: it may sit too high or off-center, make-up air may be short, wind may be pushing in through an open window, or the duct may be blocked, too long or full of elbows. Close windows, clear the duct opening, then book a visit.
Hood repair
Book a diagnostic made for your exact model and performed at the appliance itself.
Find your metro
Where the offices are, and what to tell us about getting in.

