What it means
F8 with H or h on a Thermador range means a cooking zone ran without input for a long time and the automatic time limit switched it off. Touch a control, then set that zone again.
Thermador range F8 + H/h / Modes and limits
F8 with H or h on a Thermador range means a cooking zone ran without input for a long time and the automatic time limit switched it off. Touch a control, then set that zone again.
Also appears as F8 + H/h
F8 with H or h on a Thermador range means a cooking zone ran without input for a long time and the automatic time limit switched it off. Touch a control, then set that zone again.
The zone ran for a long stretch without anyone touching the controls.
F8 appears without a long cooking time.
Your Thermador steps, stored on this device only

The zone ran for a long stretch without anyone touching the controls.

Any control element on the cooktop will do.

Then continue cooking.
If it appears after only a short cooking time, book a visit.
Give us your model number and the checks you already made, then start your request below.
Book a visitA simplified drawing, since the layout shifts from one model to the next. Tap any outlined part for its photo and the check that goes with it.
An automatic time limitation that triggers when a cooking zone runs continuously without interaction.
Read the supporting manualNo. It is a time limit, unlike F1 to F6.
Read the supporting manualThe limit switched them off; a touch lets you set them again.
Read the supporting manualManufacturer document
Thermador / BSH Home Appliances (thermador.com/us support page)
Undated web page; fetched 12.11.2026 / entry "F8 + H/h and cooking zones not heating"
Source: the ranges page of Thermador's oven support section, entry F8 + H/h.
Thermador's entry prints no time for the limit. It says only that the zone ran a long time without input.
The Thermador manual lists F8 with H or h without explaining the letters.
No, it is a safety limit that switched the zone off. Touch a control and set the zone again.
If it appears without a long cooking time.
Thermador messages, symptoms, parts, repair visits
On a Thermador Pro range, each rangetop burner has its own igniter and should catch within four seconds. If one will not, Thermador’s first suspect is a burner cap sitting out of alignment. Reseat it, dry everything, and check the knob. Several burners dead, or sparking that never stops, needs a technician.
Book a diagnostic made for your exact model and performed at the appliance itself.
Where the offices are, and what to tell us about getting in.